
Vent-free fireplace service and repair in Medley
Our family-owned team works from the rating plate and the manual, not from a guess about the model.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Vent-free gas fireplace symptoms worth reporting
- No spark at the pilot
- Roaring or whistling from the burner
- Odor that lasts past break-in
- Smoke from logs after break-in
Jump to
Vent-free gas fireplace service for homes in Medley
Blowers and heat exchangers on vent-free units
Some owners add a blower or a heat exchanger insert to push more warmth into the room. Vent-free manuals forbid those add-ons unless the maker lists them for the model. An unlisted blower changes the air around the pilot and the burner.
If one has been added, we explain why it should come out. Where the maker offers a listed blower kit, we can tell you what it is. Anything we fit comes from the maker's list, and the written record names it.
Where vent-free logs may run only as vented
One log set manual notes that some codes allow its burner to run only in a vented mode, with the damper open. The code in force for your home governs that choice, not the maker's brochure. The installation should have been set up to match.
We check how your set is being run and what its manual allows. If the unit is running vent-free where only vented use is allowed, we explain that and what would need to change. Questions about how a rule applies can also go to your local building department.
A whistle from a vent-free log set
A whistle while a vent-free unit burns usually comes from gas or air moving through a narrow gap. The manuals list pressure and debris near the burner or air openings among the causes. Sometimes a scrap of ember material or a small stone sits where it should not.
We listen at the burner, then check pressure and the openings. Moving one misplaced piece can end the noise. Where the sound comes from the control or the supply side, we say so and explain which trade handles it.
The gas connector inside a vent-free fireplace
Log set manuals set rules for how the gas connector passes into the fireplace and where it may run. A connector that rubs, kinks or sits in the flame path can fail. We look at it during every vent-free service.
If the connector or its routing is wrong, we explain what the manual requires. Work on the house supply piping belongs to a gas contractor. Anything we change on the appliance side is leak checked and listed on the written record.
Items on your vent-free fireplace estimate in Medley
- Inlet and manifold pressure readings
- Clearances to mantel, walls and floor
- Soot source traced and corrected
- Written record of the work
Ventless gas fireplace questions from Medley
What causes black soot to build up on vent-free logs?
Logs out of position, too much ember material, dirty burner ports, drafts, a propane tank running low or residue from candles in the room. We look at each cause, correct the one we find and show you the clean flame afterward.
Do you replace a failed ODS pilot with a generic part?
No. We use the pilot listed for your burner system and fuel. One maker states that a failed ODS pilot should be replaced with the same model. Pilots that look alike can differ in how they sense oxygen.
Does the inspection discount cover vent-free fireplace repairs?
Yes. Repairs, fitted parts and maintenance visits approved no later than 72 hours after your own free inspection get 10% off the agreed price. The clock starts at that inspection, not at a calendar date, and the estimate shows the discounted figure.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo
