Spalled brick replacement on chimneys in Biscayne Island
Spalling brick repair in Biscayne Island begins by marking each damaged unit during a free inspection.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Cracked and flaking brick worth a closer look
- Damage worst near the chimney top
- Spalled brick just above the roofline
- Pitted brick from past harsh cleaning
- Mortar gone around a loose brick
Jump to
From damaged unit to matched new brick
Matching mortar color around new units
A well-matched brick can still stand out if the joints around it are the wrong color. Brick industry guidance stresses matching the existing mortar color so the repaired area blends with the masonry around it.
We compare mortar samples with the existing joints, wet and dry, and use the sand and any pigment needed to get close. The new joints may look a little brighter at first. They usually settle as they weather, and we explain what to expect when the work is done.
When the count of damaged bricks grows large
Single-brick replacement suits damage scattered through otherwise sound masonry. When damaged units cluster across large areas, or whole courses are loose, cutting out bricks one by one stops making sense.
We explain where that line falls on your chimney. A partial rebuild of the affected section may be the sounder repair, and it is priced as its own job. You see both options with their reasons, so the choice between them is yours and made with the full picture. Sound sections of the chimney stay out of either scope.
A free inspection before any brick comes out
Brick replacement starts with a free inspection. We check each face of the chimney, mark damaged units and test suspect bricks. The crown, cap, flashing and joints that could be sending water into the wall are checked too.
The findings are explained on site, and a free written estimate follows that sets out every item separately. There is no charge and no obligation. If the bricks can wait, we say so and explain what would make replacement necessary. Keep the written findings for any later visit.
What to watch after bricks are replaced
Keep an eye on the chimney during the heavy rains that follow the work. Look for new flaking near the repair, stains inside or pieces on the roof. New joints may show a fine surface line while they cure, which is worth mentioning.
If anything concerns you, note where and when. Call and describe it. The written record shows which units were replaced, so we can check them and any other part of the chimney that could be involved. Most questions are easier to answer once we know which unit you mean.
What we check before quoting brick work
- Survey of damaged units on each face
- Surfaces dampened before setting
- New units toothed into the bond pattern
- Protection for roof, windows and plantings
Answers about chimney brick replacement
How do you match new brick to an older chimney?
We compare size, color, texture and the range of shades in the wall, and we can set out a sample to judge the match. Finding a close brick can take some searching. New brick may look fresher at first.
How does the inspection discount apply to brick replacement?
Say yes to the brick replacement within 72 hours after your free inspection and we take 10% off the services you book. Those hours run from your own inspection visit.
Do you replace the firebrick inside the fireplace too?
Firebrick lining the firebox is a different material and job, handled under firebox repair. Chimney brick replacement covers the exterior masonry. If both need attention, each is priced separately so you can decide.
More Ways to Care for Your Fireplace
- Chimney Chase Cover ReplacementReplace the chase top with a properly planned cover and clearly defined pipe connections.
- Prefab and Zero-Clearance Fireplace RepairIdentify and repair manufactured fireplace components using the appropriate model information.
- Chimney Crown RepairRepair the damaged chimney top with an approach matched to the crown and supporting masonry.
- Fireplace Hearth RepairRepair the hearth surface after considering the supporting assembly and fireplace requirements.
- Gas Fireplace InstallationCreate a complete gas fireplace installation plan for the room, appliance and connected systems.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo