
Chimney brick replacement done unit by unit in Hillsboro Beach
Our family team explains the cause, the match and the method in plain words.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Spalling brick signs to mention when you call
- Brick faces flaking or popping off
- A clear sealer flaking off the brick
- Chipped edges where joints were ground out
- Vines rooted over damaged brick
Jump to
Brick replacement that deals with the cause
Fragments on the roof or on the ground
Flakes of brick collecting in a gutter, on the roof or at the foot of the chimney suggest the damage is still active. Thin flakes usually come from the surface of a unit. Chunks with square edges may be corners or whole faces.
Keep a few if you find them and tell us where they landed. They help us judge the kind of damage before we reach the roof. Keep people away from the area below while pieces are still falling.
Softer brick and the mortar around it
Some brick is softer and more absorbent than others. Federal preservation guidance explains that in a wall of soft brick, a soft, permeable mortar is needed so moisture can leave through the joints rather than through the units.
If your chimney is built of softer brick, the mortar around replacement units is chosen with that in mind. A hard mix would push the problem into the bricks next to the repair. We explain the mortar choice so you can see how it protects the existing brick.
Broken brick at the chimney corners
The corners of a chimney take weather on two sides, and corner bricks can show damage first. Broken corners also let water into the joints on both faces they touch.
Corner units are replaced with care, because they tie two faces together. The replacement brick has to fit the corner detail, and the joints on both sides are pointed full. We explain whether corner damage is local or part of a wider pattern that needs another look. A corner that is replaced well also protects the joints on both sides from water.
Appliances venting into the chimney during brick work
A chimney may serve a furnace or water heater as well as the fireplace. Its flue must stay open and clear while brick work goes on, even when the new units sit close to it.
Tell us about any appliance connected to the chimney when you book. We plan the work so its flue is not blocked and debris is kept out of it. Servicing the appliance itself is outside brick replacement, and we explain if anything we see needs another trade.
Spalled brick items on a written estimate
- Water source notes before replacement
- Replacement brick matched in size
- Sample of the proposed brick match
- Separate line for wider repointing
Your chimney brick replacement questions
How many bricks can be replaced before a bigger repair is needed?
There is no fixed count. It depends on how the damage is spread and whether the masonry around it is sound and not moving. When damaged units cluster in large areas or courses are loose, we explain a partial rebuild instead.
Will new bricks stop water getting into the house?
They can close an entry point where broken brick lets water in. Water can also enter through the crown, flashing or joints. We explain what the brick work addresses, and a hose water test comes into it only if the job calls for one.
Do you replace the firebrick inside the fireplace too?
Firebrick lining the firebox is a different material and job, handled under firebox repair. Chimney brick replacement covers the exterior masonry. If both need attention, each is priced separately so you can decide.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo

