Chimney brick replacement done unit by unit in Weston

If the damage is too widespread for single bricks, we explain the wider repair it needs.

Owned and run locally
Available for same-day service
Fully licensed and insured
Family owned and run

Call Now (645) 465-4171 Book Online

Brick trouble you can spot from the yard

White deposits around damaged bricks
Earlier replacement bricks failing again
Crumbling brick near the ground
Bright hard joints beside broken faces

Jump to

How we approach spalling brick repair in Weston

Setting the new brick in line with its courses

The replacement brick is centered in the opening and pressed into position, as brick industry guidance describes. It should sit in line with the courses above and below and flush with the face of the wall.

We check its position before the mortar stiffens. A brick set proud or recessed catches water differently from the bricks around it and shows as a repair. Getting it in line is part of making the replacement disappear into the wall rather than standing out as a patch.

Matching color and the range of shades

Few brick walls are one flat color. Brick industry guidance suggests that a sample for matching should represent the full range of colors and textures of the brick selected. A single perfect-looking brick may still stand out beside the variation in your chimney.

We look at the range across each face, not just one unit. Replacement bricks are chosen to sit within that range. Where several units are replaced together, mixing shades can look more natural than a block of identical new brick.

A record of which bricks were replaced

After the work, you receive a written record listing the units replaced and where they sit on the chimney. It also notes the brick and mortar used and anything we saw that falls outside the job.

That record is useful later. If more bricks need replacing, the same brick and mortar can be sourced again. If you sell the house, it shows what was done. Keep it with your other papers about the home. It also helps a future contractor understand what is already in the wall.

White deposits beside flaking brick

White deposits near spalled brick are salts that water dissolved inside the wall and left at the surface as it dried. When they appear beside flaking faces, they show that water is moving through that part of the wall.

We treat them as a clue to the water path, not a separate problem. Finding where the water enters comes before replacing the damaged units. It may be the top, the flashing or open joints, and the new brick should not face the same wetting.

Your spalling brick repair scope in writing

Sample of the proposed brick match
Surfaces dampened before setting
Debris removal and haul-away
Aftercare notes and repellent timing

Spalled brick replacement answers

Does the fireplace need to stay unused during brick replacement?

Sometimes, while mortar around the new units cures and while any opening near the flue is closed up. Where the new bricks sit decides how long, and we give you a clear point to resume fires.

Will the new bricks look different from the old ones?

At first they may, because the old brick has weathered and the new mortar is fresh. A careful match of size, color and texture keeps the difference small, and it usually softens with time. We show you the proposed brick before approval.

Do you replace the firebrick inside the fireplace too?

Firebrick lining the firebox is a different material and job, handled under firebox repair. Chimney brick replacement covers the exterior masonry. If both need attention, each is priced separately so you can decide.

Proudly American

Family owned and operated in Miami, Florida.

Call Now (645) 465-4171

Book Your Free Inspection in Miami

(645) 465-4171

Chimney & Fireplace Brands We Work With

DuraVent
Olympia Chimney and Venting
Copperfield Chimney Supply
Rutland
Heatilator
Heat & Glo