Skip to content
(645) 465-4171

Chimney inspection that starts with your question in Weston

Upfront pricing, no hidden fees and time to ask about every line of the estimate.

  • Owned and run locally
  • Available for same-day service
  • Fully licensed and insured
  • Family owned and run

What prompts a fireplace inspection

  • Water stains near the chimney
  • Smoke coming into the room
  • Cracks in the crown or brick
  • Sounds of animals in the flue
Jump to

Chimney inspection findings you can act on

Inspecting a factory-built fireplace

A factory-built fireplace is listed together with the chimney system it was tested with. The Florida Building Code requires both to be installed as the listing and the manufacturer's instructions say. We look for the listing label, the model and the parts that belong to it.

Panels, the firebox shell, the damper and the visible chimney sections are checked for cracks, rust, gaps and damage. We compare what we see with what the manual shows. Repairs have to use listed parts, so identifying the model matters before any estimate.

Flues that serve another appliance

A chimney may carry a flue for an appliance other than the fireplace. The Florida Building Code's fuel gas volume covers how gas appliances vent through chimneys. Each flue should serve the equipment it was built or lined for.

We identify each flue and what connects to it, as far as access allows. If a gas appliance vents into the chimney, we note the condition of its flue and the top. We also tell you when the appliance itself needs a gas service visit. We do not guess at connections we cannot see.

Checking the lintel above the opening

Above the fireplace opening, a lintel carries the masonry over the gap. Heat and water can rust a steel lintel or crack the masonry around it. A sagging line above the opening or cracks running up from its corners are worth a close look.

We look at the lintel where it can be seen and at the brick or stone around it. If the lintel is concealed behind a finish, we say so. Repair of a failing lintel is a separate job, and we explain whether it limits use of the fireplace.

Findings explained before we leave

At the end of the inspection, we go through what we found at the fireplace and, where useful, outside. Each finding is linked to the part it concerns and to what it means for use. You can ask questions while the evidence is in front of you.

We separate confirmed defects from things that look suspect but cannot be confirmed. We also say what is in good order. A list of problems without that context is hard to act on, so we give you the whole picture.

What sits inside the inspection scope

  • Listing label on a factory-built unit
  • Attic view of the chimney where reachable
  • Findings ranked by effect on use
  • Signs of animals or nesting

Chimney inspection questions, answered plainly

What if part of the chimney cannot be seen?

We tell you which part, why it could not be seen and whether it matters for your question. The written record lists it. If more access is needed, we explain what it would involve and what it would cost.

Can you find where water is getting into the chimney?

Usually. We look at the crown, cap, flashing and masonry with the timing of the water in mind. When looking alone is not enough, a hose water test can narrow it down when the job calls for it.

What happens if you find an animal in the chimney?

We stop before anything is disturbed. Some species and active nests are protected, so the next step may be a wait, a referral or an animal removal visit. The entry point is noted for repair once the flue is empty.

Proudly American

Family owned and operated in Miami, Florida.

Call Now (645) 465-4171

Book Your Free Inspection in Miami

(645) 465-4171

Send your details for a free Miami chimney or fireplace inspection. We will call to confirm the appointment.

Chimney & Fireplace Brands We Work With