Sealing or rebuilding the chimney crown in Pembroke Pines
Crown repair from a locally owned team that explains each step and backs the work with a warranty.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Crown cracks and other early warnings
- Crumbling edges along the crown overhang
- Water standing on the crown after rain
- Dampness at the fireplace after heavy rain
- Crown and brick separating along the top course
Jump to
Sealing a sound crown or replacing a failed one
Choosing the sealant for the flue joint
Not every tube of caulk belongs on a chimney top. Brick industry guidance recommends a good grade of polysulfide, butyl or silicone rubber sealant at this joint and warns against oil-based sealants. Proper priming and a backing rope are part of the detail.
We tell you which sealant family we plan to use and why. The joint is cleaned and prepared before the new bead goes in. If an earlier repair used a product that has cracked or hardened, we remove it rather than run a new bead over the top.
Using the fireplace during and after crown work
A fire sends heat and gases up past a crown that may still be curing. For that reason, fireplace use is usually paused while crown work is in progress. The waiting time afterwards depends on the material used and the weather during curing.
We give you written instructions at the end of the job. They say when the fireplace can be used and what to watch for. If an appliance other than the fireplace vents into the chimney, tell us before we start so its flue stays clear throughout.
The workmanship warranty on crown work
The agreed crown work is covered by our workmanship warranty. That covers how we did the job you approved. It sits alongside the product instructions, which describe how the material itself should be treated while it cures.
If something about the crown concerns you after the job, call us and describe it. The written record helps us compare what you see with what was done. Problems from a separate part, such as a damaged cap or flashing, are discussed openly as their own items.
When crown sealing is the wrong recommendation
Sealing is a smaller job than replacement, so it is tempting to hear that a crown only needs a coat. On the wrong crown, that answer buys a short delay and another repair later. The coating will not hold loose concrete in place.
We recommend sealing only when the crown meets the conditions the product requires. When it does not, we say so plainly and explain what replacement involves. You make the decision, but you make it with an accurate picture of the top of your chimney.
Items on a chimney crown estimate in Pembroke Pines
- Overhang and drip edge check
- Crack preparation before any coating
- Elastomeric crown coating where suitable
- Curing time and weather protection
Crown sealing and replacement answers
Can a crown with fine cracks be sealed rather than replaced?
It can, when the concrete around the cracks is firm and the crown still sheds water. A crown coating goes on a clean, dry and sound surface. If the top is loose, hollow or flat, sealing only hides the fault, so we explain replacement instead.
Will a new cap stop water coming through the crown?
No. A cap covers the flue opening, while the crown covers the masonry around it. Water that enters through a broken crown keeps entering under a new cap. We check both parts and price each one on its own line.
Is there a better time of day for crown coating work?
The product data sets temperature limits and asks for a dry surface with no rain due. On hot days we may work earlier or later so the coating goes on within those limits. We confirm timing when we schedule.
More Ways to Care for Your Fireplace
- Top-Sealing Damper InstallationFit a top-mounted damper only after checking the fireplace, product restrictions and control route.
- Firebox RepairRepair the damaged fireplace chamber using an approach suited to masonry or manufactured components.
- Prefab and Zero-Clearance Fireplace RepairIdentify and repair manufactured fireplace components using the appropriate model information.
- Stone Chimney RepairRepair affected stone chimney surfaces with the supporting construction and visual match considered together.
- Hurricane and Storm Damage Chimney RepairAssess storm-related chimney concerns and distinguish temporary protection from permanent component repair.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo