Chimney crown replacement and repair across Richmond West
Upfront pricing for crown work, with any extra item explained before it is added to the job.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Clues that the chimney crown lets water in
- Dried or split caulk around the flue
- Dark streaks on the brick below the top
- Peeling coating from an earlier repair
- Loose cap fixings set into the concrete
Jump to
Crown repair that starts with an assessment
Moss and organic growth on the crown
A crown that stays damp can support moss or other growth. The growth holds moisture against the concrete and keeps the surface wet longer after rain. It also hides cracks that would otherwise be easy to see.
Before any crown repair, the surface is cleaned so the concrete can be assessed. If growth has returned after earlier cleaning, that tells us water lingers on the top. We look at slope and drainage as the cause, rather than treating the growth as the only problem.
Crown repair on a stucco-finished chimney
A masonry chimney finished in stucco still needs a crown at the top. The stucco covers the sides, while the crown sheds water from above. Where the two meet, cracks and staining can show.
We assess the crown and the edge of the stucco together, but price them apart. Crown work covers the top. Cracked or loose stucco on the sides belongs to stucco repair. If the chimney turns out to be framed rather than masonry, it has a chase cover instead of a crown, and we say so.
Crowns and dampers mounted on the flue top
Some chimneys carry a damper mounted on the flue top, worked by a cable from the fireplace. Its frame usually sits on the liner or on the crown around it. Crown repair may need that damper taken off and set back.
We check how the damper is fixed and whether it is in working order. If it can be reused, it is reinstalled when the crown work is complete. If it is damaged, replacing it is a separate item with its own explanation. The crown scope does not hide damper work.
Keeping the flue sealant joint in good order
The sealant joint at each flue is often the first part of a crown to wear. Brick industry maintenance guidance expects sealants to need replacing well before the masonry around them. A split or hardened bead lets water run between liner and crown.
During maintenance visits we check that joint on every flue. Failed sealant is cut out, the joint is cleaned and primed, and a new bead goes in over backer material. It is a small job that protects the larger work of the crown.
The crown repair items you approve
- Overhang and drip edge check
- Crack preparation before any coating
- Reinforcement planned for a new crown
- Bond-break layer under new concrete
Crown repair answers for Richmond West
Will a new cap stop water coming through the crown?
No. A cap covers the flue opening, while the crown covers the masonry around it. Water that enters through a broken crown keeps entering under a new cap. We check both parts and price each one on its own line.
Why does a new crown need to overhang the brick?
An overhang with a drip edge throws water clear of the brick face instead of letting it run down the chimney. The code also calls for a drip edge on the top of a masonry chimney. Without one, water can keep soaking the top courses.
How does the inspection discount apply to crown repair?
Approve crown work in the 72 hours after your free inspection and a 10% discount applies to it. The window runs from your own inspection, and it covers any service on the estimate you book in that time.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo