Chimney damper repair, part by part, in Wynwood
Our family team restores damper control from the room and hauls the old parts away afterward.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What a failing throat damper looks like
- Plate drops shut while a fire burns
- Rattling above the fireplace on windy days
- Control rod slipping out of its notch
- No damper visible above the opening
Jump to
Damper service for fireplaces in Wynwood
When heat has warped the plate
Cast plates can warp after repeated hot fires, or after one very hot one. A warped plate no longer lies flat against its frame, so it leaks air when closed and can bind when opened. The fault may show as an uneven edge when you look up with a flashlight.
A slight warp does not always justify a new damper. We judge whether the plate still opens fully and closes well enough to do its job. Where it binds or leaves a wide gap, a replacement plate or a new assembly goes on the estimate, with the reason written next to it.
What a throat damper seal can achieve
A cast throat damper closes metal against metal. Even a new one leaves small paths for air around the plate. That is normal for the design and not a sign of poor work.
What you should expect after repair is a plate that closes fully and evenly, without wide gaps or rattle. If you want a closer seal than a throat damper gives, tell us. We explain the options and what each would change, rather than promising more from the throat damper than it can deliver.
What the free inspection covers for a damper
The free inspection looks at the damper plate, frame, pivots and control, and at how far the plate travels. We also look at the smoke shelf and the throat around the frame, since both affect the damper.
We tell you what we found, what it means for use, and what we recommend. The findings become a free written estimate. If something is outside the damper, such as the firebox or the chimney top, we mention it and list it separately so you can decide on each item.
More than one damper fault at once
A damper can have more than one problem, for example a rusted pivot and a bent control rod. Fixing only one leaves the plate still hard to use.
We list each fault we find and what it takes to put right. Sometimes the combination makes replacement the better value, and sometimes a few small repairs are enough. We explain the reasoning, so you understand why the estimate says what it says and can question any line of it. Each fault keeps its own line and price.
The damper scope we write down
- New damper assembly, where needed
- Listed parts for factory-built models
- Chimney top water source noted
- Free written estimate before any work
Damper questions worth asking
My damper handle snapped off. Is a new control enough?
Often, yes. If the plate and frame are sound, a replacement handle or rod may be all the damper needs. We check the plate and pivots before ordering anything, because a snapped handle sometimes points to a stuck plate.
Can you fit a new damper in a fireplace that has none?
Usually. We check whether the throat will take a new throat damper. Where it will not, a different closure option may suit the fireplace, and we price it separately. You choose once both options are explained.
Can you replace the damper in a factory-built fireplace?
Yes, using the parts the manufacturer lists for that model. We need the model and serial number from the label. Unlisted parts are not fitted, because the fireplace's listing depends on its tested components.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo