Chimney flashing reset, resealed or replaced in Riverside Park
Clear boundaries between flashing, masonry and roofing work, written down before anyone lifts a tile or shingle.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Flashing trouble you may notice in Riverside Park
- Water stain on the ceiling beside the chimney
- Thick black roof cement around the base
- Gaps along the top edge of the metal
- Leaks only when wind drives the rain
Jump to
What goes into a lasting flashing repair
Scheduling flashing work around rain
Flashing work opens the roof at the chimney, so the weather on the day matters. Sealants also have conditions for application and curing, set by their makers. A forecast of heavy rain may move the date.
We tell you as early as we can if the weather changes the plan. If rain arrives during the job, the open area is covered before work stops. We would rather reschedule than leave an opening exposed or apply sealant to wet surfaces against the product instructions.
A wet ceiling with a dry firebox
Where the water appears inside can hint at the path. If the ceiling or wall beside the chimney is wet while the firebox and damper stay dry, the roof junction is a likely suspect. If the firebox is wet, water may be coming in at the top of the flue instead.
Neither pattern is proof on its own, but it tells us where to start. Tell us whether you have seen water inside the fireplace itself. We then check the flashing and the top together, and the findings say which evidence pointed where.
Brick damage right at the roof line
The bricks just above the roof line can stay wet longer than the rest of the chimney, because runoff and splash from the roof keep hitting them. Over time their faces may flake or their joints may wash out, right where the counter flashing is set.
We check those courses closely. If the brick is sound, the counter flashing goes back into its joint. If faces are breaking away, the brick work is listed separately, and we explain whether it should happen before the new flashing goes in.
Flashing metal in salt air
Near the coast, chlorides in sea air react with zinc coatings on galvanized steel and wash away the protective layer, exposing fresh zinc again and again. Galvanized flashing and fasteners can wear faster there than they would inland.
Brick industry guidance already favors stainless steel or copper for chimney flashing, and near salt water that choice matters more. We explain which metal we propose for your chimney and why. If old galvanized pieces show heavy rust at laps and fasteners, the findings describe it face by face.
Scope notes for chimney flashing work
- Roofing lifted and restored at the chimney
- Roof deck condition where exposed
- Crown and cap noted as separate items
- Attic framing beside the chimney
Flashing questions we hear in Riverside Park
Will you need to go into the attic?
It helps if the attic is reachable. Stains, damp framing or wet insulation beside the chimney tell us a lot about where water gets in. Please clear a path to the hatch. If there is no access, we work from the roof and the rooms below.
How long does chimney flashing repair take in Riverside Park?
It depends on the roof covering, the number of faces and whether a reglet has to be recut. A single face on a shingle roof is quicker than a full reflash on tile. The estimate gives the expected duration for your job.
Can you repair flashing where a metal roof meets the chimney?
Yes, with details that follow the panel profile and the roofing maker's instructions. We identify the panel type first. If cutting or refitting panels is better done by a roofer, the estimate says so and shows where our part of the work ends.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo