Joint and tile repair inside chimneys in Goulds
Approve the flue work within 72 hours of the free inspection to save 10% on the tiles and joints.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a clay flue starts breaking down
- Weaker draft than the fireplace used to have
- An earlier chimney fire in the flue
- Cracks in the chimney brick near the top
- A top tile broken off low
Jump to
How a damaged flue gets repaired in Goulds
Clay pieces found in the fireplace
Pieces of clay or crumbs of mortar on the smoke shelf or firebox floor are one reason people call about the flue. They show that something above is breaking down. They do not show how much of the lining is affected or where.
Keep a few of the pieces if you can, and tell us when you first noticed them. We trace them back to the damaged area during the free inspection in Goulds. Stop using the fireplace until the source is found, rather than guessing from the size of a fragment.
Keeping the chimney closed between work days
Flue repair can run across more than one day, especially with curing between stages. The top of the chimney may be open while work is underway. A cover goes over the flue top before we leave the roof each day, keeping rain and leaves out.
Inside, the fireplace opening is protected and the area is left clean. Debris from loose tile, mortar ridges and cleaning is cleaned up and hauled away. If the fireplace must stay closed during curing, we tell you how long to plan for. Nothing is left loose on the roof overnight.
Written flue findings for homes in Goulds
The findings we give you after a flue assessment in Goulds describe each defect: where it is, what it looks like and how confident we are about its extent. They also name the sections we could not see.
That record is useful even if you decide not to repair right away. It shows the next person where to look. If you go ahead, the estimate refers back to the same findings, so the repair can be matched to what was actually found. They also help if another company is asked to quote the same flue.
The final check after a flue repair
When the repair material is in place, the flue is checked along its length as far as it can be seen. Repair instructions call for that final look, to confirm the material covers the sections it was meant to cover.
We tell you what the final check showed and note it in the written record. If a section could not be seen after the repair, as before, that is stated. The record then gives you and any later visitor an honest picture of the flue. Any area that looks thin or missed is dealt with before we pack up.
Preparation and repair in a flue quote
- Refractory mortar for any rejointing
- Room protection at the fireplace
- Chimney top covered at each day's end
- Repair debris cleaned up and hauled away
Flue repair answers for homes in Goulds
Why would a repair make my flue too small?
Repair material takes up some room. For an appliance, the flue must stay at least as large as its connector and the size its manual requires. For a fireplace, it must stay in proportion to the opening. We check both first.
Do you use ordinary mortar to fix flue joints?
No. Flue tile joints call for refractory mortar or a listed repair material made for the inside of a flue. Ordinary masonry mortar and patching compounds break down in those conditions. The estimate names the material used.
Who checks the chimney outside the flue during a visit in Goulds?
We do, as far as it is visible. Clearances, the crown, the cap and the masonry are noted during the assessment. Anything outside the lining repair is listed as its own item, so each decision stays separate.
More Ways to Care for Your Fireplace
- Chimney TuckpointingRenew deteriorated mortar joints around chimney bricks that can appropriately remain.
- Chimney Liner Installation and ReliningPlan a compatible chimney liner installation with the existing passage, connections and maintenance access considered together.
- Chimney Cap Installation and ReplacementProtect the chimney opening with a cap chosen for its fit, attachment and compatible system.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo