Repairing a damaged chimney flue in Little Havana
The method is matched to what the flue serves, not to a favourite product.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a clay flue starts breaking down
- Flaking clay inside the flue
- Weaker draft than the fireplace used to have
- A lightning strike on or near the chimney
- Cracks in the chimney brick near the top
Jump to
Flue lining repair for homes in Little Havana
Washed-out mortar between clay flue tiles
Clay flue tiles are set in mortar joints, and those joints take the worst of the heat, moisture and chemicals in flue gases. Over time the mortar can wash out and leave voids between tiles. A flue with open joints may look intact from the fireplace.
Repair manufacturers list joint gaps among the lining defects their systems are designed to address. We look along the flue for missing mortar and note where the gaps are. The finding tells us whether a joint repair method could reach them, or whether the damage has gone further than the joints.
How far a local tile replacement can reach
Replacing a single tile works where the damaged tile can be reached, usually near the top. Tiles deeper in the chimney sit inside the masonry. Reaching them one by one can mean opening the chimney wall, which changes the scope entirely.
We tell you where the damaged tiles are and what reaching them would take. If local replacement is only practical at the top, the estimate says so. Deeper defects then point toward resurfacing, if the flue qualifies, or toward relining. The findings mark each damaged tile's position as closely as we can judge it.
Where the flue begins above the fireplace
Above a masonry fireplace, the first clay tile rests on the sloping walls of the smoke chamber, and every tile above stacks on it. Building rules begin the lining at that point. A defect there can belong to the tile, to the chamber that holds it, or to both.
We look at the lowest tiles from the fireplace and describe what we see. Repairs to the chamber itself belong to smoke chamber repair and are listed separately. The flue repair estimate covers the lining, and the two decisions stay visible side by side.
Protecting the room during flue repair
Much of a flue repair happens from the roof, but debris and dust can fall into the fireplace as the passage is cleaned and prepared. The area around the opening is covered before work begins.
Point out any stone, tile or wood near the fireplace that marks easily. Some repair materials stain what they land on, so covering the hearth and surround is part of the plan. Each evening the hearth area is swept and wiped, and the bagged debris leaves with us. Furniture near the hearth can stay if there is room to work safely around it.
Flue repair scope written out in full
- Cleaning of soot and glazed deposits
- Loose tile and mortar removal
- Top tile replacement where needed
- Repair system listing named in writing
Flue repair answers for homes in Little Havana
How do you know whether my flue qualifies for resurfacing?
The repair system's instructions set the conditions: sound, clean and dry tiles, cracks that will not let pieces loosen, protruding mortar removed, and enough flue size left for the appliance or fireplace. We check each one and tell you the result.
What should I tell you when I call about the flue?
What the flue serves, when you first noticed fragments or a change, and whether anything unusual happened, such as an earlier chimney fire or a lightning strike. Earlier inspection notes and invoices help too.
Who checks the chimney outside the flue during a visit in Little Havana?
We do, as far as it is visible. Clearances, the crown, the cap and the masonry are noted during the assessment. Anything outside the lining repair is listed as its own item, so each decision stays separate.
More Ways to Care for Your Fireplace
- Chimney Cap Installation and ReplacementProtect the chimney opening with a cap chosen for its fit, attachment and compatible system.
- Spalling Brick Repair and Chimney Brick ReplacementReplace deteriorated chimney bricks while retaining suitable surrounding masonry.
- Chimney Crown RepairRepair the damaged chimney top with an approach matched to the crown and supporting masonry.
- Chimney Animal RemovalAssess occupied chimney openings and plan appropriate follow-up cleaning or entry protection.
- Chimney RebuildRebuild the affected chimney section with the retained structure, roof connection and passage included in the plan.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo