
A chimney inspection in Bay Colony with findings explained
Our family team inspects the chimney you have, masonry or factory-built, against what it should be.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When to have the fireplace inspected
- Scorch marks near the fireplace opening
- Cracks in the wall beside the fireplace
- Rust stains running down the chimney
- No record of any earlier inspection
Jump to
What the inspection covers and what it cannot
Inspecting a stucco-finished chimney
A chimney finished in stucco may cover masonry block or a framed chase. The two assemblies behave differently, and a crack means more on one than the other. Staining, bulges or soft spots can point to water behind the finish.
We tap and look where the finish can be reached and ask what you know about how the chimney was built. If the assembly behind the stucco cannot be confirmed, the record says so. Any repair recommendation explains which layer it addresses.
Inspecting a fireplace with an insert
An insert sits inside the old firebox and normally sends its smoke up a liner fitted into the flue. We look at the insert's surround, the connection to the liner where it can be seen and the top of the liner. The insert's manual sets how it should be installed.
Some parts cannot be seen without moving the insert. We tell you which ones and what moving it would involve. If moving it is needed to answer your question, that step becomes its own agreed scope.
When the flue needs cleaning to be judged
A thick layer of soot hides the surface of the flue. Cracks, gaps and missing joints can be impossible to judge under it. In that case, we tell you which parts could be seen and which could not.
If the unanswered part matters, a cleaning may need to come before a full judgment of the lining. We explain whether that is likely to change the decision in front of you. If it is not, we do not suggest it. That keeps the steps to the ones that actually help you decide.
What you keep after an inspection in Bay Colony
Every inspection in Bay Colony ends the same way. You know what was looked at, what was found, what could not be seen and whether the fireplace should be used as it stands.
Those points are written down for you along with any estimate. If a repair is suggested, you decide when and whether to go ahead. Keep the record with the manual so it is easy to find for the next visit. The next inspection can then start from where this one ended.
Your chimney inspection in Bay Colony, itemized
- Crown condition at the chimney top
- Deposits and blockages in the flue
- Metal liner top plate and cap
- Flue size compared with the opening
What to know about the inspection visit
Can the inspection trace an odor coming from the fireplace?
It aims to. Tell us when the smell appears. We look at deposits, water in the masonry, debris on the smoke shelf and air moving down the flue, then explain which source the evidence supports.
Do you look at the crown during the inspection?
Yes, when the roof can be reached safely. We look for cracks, failed sealant where the crown meets the flue and a top that holds water. Hairline cracks and wide splits call for different repairs, and we explain which applies.
Can I watch while the chimney is inspected?
Yes. You are welcome to follow along, and we point out parts as we go. Seeing the crown or the smoke chamber once makes the findings much easier to understand.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo
