Inspecting the chimney and fireplace in Rock Island
Tell us what worries you about the fireplace and the inspection is planned around that question.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Reasons to have the chimney inspected
- Pieces of tile in the firebox
- White deposits on the chimney brick
- Roof work finished around the chimney
- A strong storm has passed through
Jump to
Inspecting your chimney in Rock Island, part by part
Checking the firebox walls and floor
The firebox takes the direct heat of the fire. We look at the firebrick or panels for cracks, missing pieces and open joints. Gaps in a masonry firebox can let heat reach the material behind it. The Florida Building Code's fireplace section sets how firebox walls and their joints are built.
Soot patterns inside the firebox also tell a story. Smoke marks on the face above the opening, or streaks running down from the damper, can point to a draft or water issue further up. We note each observation and link it to what we find above.
Findings explained before we leave
At the end of the inspection, we go through what we found at the fireplace and, where useful, outside. Each finding is linked to the part it concerns and to what it means for use. You can ask questions while the evidence is in front of you.
We separate confirmed defects from things that look suspect but cannot be confirmed. We also say what is in good order. A list of problems without that context is hard to act on, so we give you the whole picture.
When the flue needs cleaning to be judged
A thick layer of soot hides the surface of the flue. Cracks, gaps and missing joints can be impossible to judge under it. In that case, we tell you which parts could be seen and which could not.
If the unanswered part matters, a cleaning may need to come before a full judgment of the lining. We explain whether that is likely to change the decision in front of you. If it is not, we do not suggest it. That keeps the steps to the ones that actually help you decide.
Inspecting the chimney after a new roof
A roof replacement disturbs the joint between chimney and roof. Flashing may have been reused, replaced or left short, and debris or tarps may have ended up on the chimney top. CPSC guidance warns that chimneys should not be blocked by tarps or debris during renovation.
We look at the flashing, the top and the flue for anything left behind. Findings are linked to the roof work where the evidence supports it. That can help if you need to raise a problem with whoever did the roof.
What the free chimney inspection covers
- Visible clearances to combustible material
- Deposits and blockages in the flue
- Chimney height relative to the roof
- Concealed parts named as concealed
Asking about an inspection in Rock Island
Do you give a written record after the inspection?
Yes. It lists the parts looked at, how each was reached, what was found and what could not be seen. Any repairs are on a separate written estimate so you can compare them easily.
Do you inspect the attic around the chimney?
When the chimney passes through an attic that can be entered safely, yes. It can show water stains on framing and clearances that cannot be seen from the roof or the room.
Is a quick look from the ground enough?
It can spot a missing cap, a leaning stack or loose brick. It cannot show cracks in the crown, gaps in the flashing or the condition of the lining. We tell you what a ground view could not confirm.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo