
Chimney leak repair for your home in Tamarac
Tracing first, repair second, then a check with the next storm, for each chimney leak we take on in Tamarac.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Water marks that suggest a chimney leak
- Paint bubbling on the chimney wall
- Dripping sounds inside the chimney in rain
- Rust streaks down the chimney or chase
- Chunks of concrete or tile in the firebox
Jump to
From ceiling stain to leak entry point
A leak is a path, not a spot
The place where water shows up inside is rarely the place where it gets in. Water that enters a chimney can run along the flue, the brick or the framing before it finds a way into a room. The stain marks the end of the path, not its start.
That is why chimney leak repair begins with tracing rather than patching. We work back from the mark you can see to the opening that feeds it. Only once that opening is found does the repair itself get written, so the work fixes the cause instead of covering the result.
Leaks from a framed chimney chase
Some chimneys are a metal flue inside a framed box finished in siding or stucco. On these, the metal cover at the top of the box is a common way in. Rust holes, open seams or a flat top that holds water can let rain run down inside the chase.
Water inside a chase can soak the framing and appear on walls or ceilings nearby. We check the cover, the collar around the flue pipe and the siding below it. If the cover is the source, it is quoted as its own item, and any damage inside the chase is assessed separately.
Water streaming down the brick face
A chimney top that sheds water off its edges keeps the brick below drier. Brick industry guidance describes crowns with an overhang and a drip so water falls clear of the face. Where the top is flush or cracked at the edge, water runs down the brick and soaks in.
Dark streaks on the brick below the top after rain can be a sign of this. We check how the top sheds water and where the face stays wettest. If the top is the reason the brick is soaking, its repair is listed first, ahead of any masonry work lower down.
Roof shapes that pour water at the chimney
The shape of a roof decides how much water reaches the chimney. Two roof planes may meet in a channel that ends at the stack. A broad slope may drain straight onto its back. Either one raises the load on the chimney sharply.
If your chimney sits in a spot like that, a leak may appear only in heavy rain, when the volume overwhelms the junction. We look at where water comes from on the roof as well as at the chimney. The findings say whether the roof shape is part of the problem.
Leak details settled before you approve
- Crown surface and edges
- Damper and smoke shelf water marks
- Firebox floor and hearth
- Follow-up after the next heavy rain
Plain answers about leaking chimneys
Can you find a chimney leak that only happens in some storms?
Often, with patience. Your log of when it leaks, the wind direction and where the water appears narrows the search. When the job calls for it, wetting one area at a time with a hose helps, though no hose fully copies wind-driven rain.
How can the stain appear so far from the chimney?
Water rarely drops straight down from where it enters. It follows framing, the flue or the inside of a wall until it finds a way out. The mark shows the end of that route, and we trace it back to the start.
Will a waterproof coating stop the chimney from leaking?
Not on its own. Water repellents reduce how much water brick absorbs, but they do not close cracks, open joints or gaps at the top and the roof line. The physical path has to be repaired first.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo
