Chimney crack and brick repair in Bal Harbour

A workmanship warranty on the masonry repairs we complete, and a written record of what was done.

Owned and run locally
Available for same-day service
Fully licensed and insured
Family owned and run

Call Now (645) 465-4171 Book Online

Brick and mortar problems on a chimney

Bricks that rock or sit loose
Gaps where old mortar has washed out
Top courses shifted out of line
Crumbling brick near the roof line

Jump to

Our approach to chimney brick and joints

Roots in the mortar joints

Plants that take root in chimney joints hold moisture against the brick and pry the joints wider as they grow. The brick industry's maintenance guidance treats plant removal as a step before masonry repair.

Pulling established plants out by force can take mortar and brick faces with them. We remove growth carefully, clear the roots from the joints and then repoint. If climbing plants are trained up the chimney, trimming them back afterwards helps the repaired masonry stay dry. The removal and the repointing appear as separate lines on the estimate.

Holes left by old brackets and anchors

Antenna brackets, dish mounts, lights and cable clips often leave holes, rusted anchors and cracked brick behind. Each open hole lets water into the masonry, and rusting metal can crack the brick around it.

The Florida Building Code also does not allow a chimney to carry loads beyond its own weight unless it was designed for them. We note what is fixed to the chimney, remove unused anchors where you agree and repair the holes. Anything still in use is discussed with you before it is moved.

Gutters spilling onto chimney brick

A gutter that overflows next to the chimney, or a downspout that empties against its base, can soak the masonry far more than rain alone. Joints in those spots wear faster and stay damp longer.

We note where roof water reaches the chimney and whether gutters and downspouts nearby are working. Clearing or redirecting them is not masonry work, but pointing it out can protect the repair. The masonry damage already caused is priced as usual, and we suggest the order that makes most sense.

Questions to ask about a masonry repair

Ask what caused the damage and how the repair addresses it. Ask how the old mortar will be removed, how the new mortar is chosen and how the color will be matched.

Ask what happens if more damage is found, how the roof and ground will be protected and when the fireplace can be used again. Good answers to those questions tell you more about a masonry estimate than the total at the bottom. We expect those questions and answer them on the visit.

Line items for chimney crack repair

Masonry at the flashing joint reset
Debris removal and haul-away
Base courses and ground contact checked
Tie-in with crown and flashing work noted

Chimney masonry questions asked in Bal Harbour

Do you replace single bricks or whole sections?

Both, depending on the damage. A few broken units can be cut out and replaced. When loose or damaged brick runs through several courses, relaying that section is usually the sounder repair.

What if a crack in my chimney looks structural?

Cracks through several bricks, stepped cracking or a stack moving away from the house can point to a structural cause. We explain what we see and when an engineer should assess it before masonry repair.

Will masonry repair change how my chimney looks?

New work can look fresher than weathered brick at first. We discuss color, texture and joint finish before you approve, and show samples where the appearance matters to you.

Proudly American

Family owned and operated in Miami, Florida.

Call Now (645) 465-4171

Book Your Free Inspection in Miami

(645) 465-4171

Chimney & Fireplace Brands We Work With

DuraVent
Olympia Chimney and Venting
Copperfield Chimney Supply
Rutland
Heatilator
Heat & Glo