Repairing cracked chimney brickwork in Homestead
Masonry repairs that respect the brick you keep, with samples shown where appearance matters.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Chimney masonry damage you can see
- Mortar that crumbles when touched
- Faces flaking off individual bricks
- Caulk smeared over cracked joints
- Paint peeling off chimney brick
Jump to
Chimney masonry from the roof line down
Cracks that run through several bricks
A crack that cuts straight through a row of bricks, rather than following the mortar, suggests a force strong enough to break the units themselves. The brick industry lists this among the signs of a structural issue.
Filling such a crack with mortar does not deal with the force behind it. We describe the crack's path and length in plain words and say when a structural assessment should come before the masonry is priced. If the assessment clears it, the repair then goes ahead with the cause understood.
Metal inside the masonry
Some chimneys contain steel: ties to the house, anchors for old fixtures or angles at openings. When steel inside masonry rusts, it swells, and that swelling can crack joints and push brick faces off.
Rust stains that bleed from a joint, or cracks that line up with a known tie, suggest this is happening. The brick industry lists accumulated rust on steel in masonry among the signs that deserve closer investigation. We explain what we see and how the metal can be dealt with as part of the repair.
Chimneys built with hollow block
Some masonry chimneys are built with hollow concrete units rather than solid brick. Under the Florida Building Code, a chimney wall of hollow block has its cells filled solid with grout. A chimney faced with stucco or brick may hide which one you have.
We confirm the construction where we can see it. The repair method changes with the unit type, and a void where grout should be is a finding in its own right. Stucco over block has its own service, and we name it when the finish is the main problem.
Wetting one face to confirm a masonry leak
Where it is needed to confirm a leak through the brick, we wet the masonry with a hose, one area at a time, while someone watches inside. We start low on the chimney and work upward, so each area is tested on its own.
Most masonry visits do not need a test, because the damage and the water path are clear. We explain beforehand which area will be wetted and what we hope to learn. A clear result can narrow the repair to the joints or units that actually let water in.
What your chimney mason prices
- Cut-out and replacement of broken units
- Joint finish matched to the old profile
- Gentle cleaning tested on a small area
- Base courses and ground contact checked
Chimney masonry questions asked in Homestead
Should the brick be sealed after the masonry repair?
Only if it helps your chimney. A vapor-permeable water repellent can be applied once repairs are complete and dry. It is a separate option on the estimate, not a replacement for the repair itself.
Do you need to go on the roof for chimney masonry work?
For work above the roof line, usually yes. We plan the route and protection so the roof covering takes as little wear as possible, and we tell you if a roofer needs to lift any covering.
Do you test for water entry before repairing brickwork?
When the job calls for it, a hose water test on one area at a time can confirm where water gets in. Most masonry visits do not need one, and we explain when it would help.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo