Taking a chimney down and rebuilding it in Flagami
A rebuild starts with a clear removal boundary, agreed with you before any brick comes down.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When patching gives way to rebuilding
- A gap widening between chimney and wall
- Daylight through the masonry in the attic
- Brick falling onto the roof
- Masonry too loose to hold new flashing
Jump to
Rebuilding the stack with the flue in mind
Rebuild work inside the attic
When a rebuild goes below the roof line, part of the work happens inside the attic. That means access through a hatch or opening, dust control and protection for insulation and anything stored nearby.
Tell us where the attic access is and what is stored around the chimney. We plan the route for materials and debris and protect the rooms below. The attic side of the rebuild is listed on the estimate, so the effort is visible rather than hidden in the masonry line.
Using the fireplace again after the rebuild
Once the new mortar and crown have cured, the fireplace can go back into use. We give you the date in the written record of the work, based on the materials used and the weather during the job.
If anything about the fireplace seems different afterwards, stop using it and tell us what you noticed. A new smell, a stain or smoke where you did not see it before are examples. If nothing changes, no further step is needed. The workmanship warranty and the written record cover the rebuilt section if a question comes up.
How a rebuild estimate is laid out
A rebuild estimate should read like a project plan. Each stage has its own line: access and protection, removal to the agreed line, new courses, the flue lining, flashing, crown, cap and cleanup.
Separate lines let you compare quotes and see where the money goes. They also show what is not included, such as roofing work by another trade. Ask about any line that is unclear, and we will explain what it covers and why it is there. A single rebuild figure with no breakdown makes that comparison impossible.
When only the top needs work
Sometimes the masonry is sound and the problem is the crown alone: cracks, a missing overhang or a flat mortar wash. In that case, chimney crown repair addresses the top without taking any brick down.
We check the top courses under the crown before suggesting a crown-only repair. If they are loose or soaked, the crown and the courses below may need to be handled together. The estimate explains which case applies. A crown repair is a far smaller job than a rebuild, so it is worth ruling in or out first. We tell you plainly which way the evidence points.
What a chimney rebuild estimate lists
- Dismantling to sound masonry
- Removal boundary marked and agreed
- Sound original brick cleaned for reuse
- Top height checked against the code
Questions about chimney rebuilding
What happens to the flue lining during a rebuild?
The lining is rebuilt with the masonry, either as new clay flue tiles set as the courses rise or as a listed liner. The choice depends on the appliance connected, and it is priced as its own line.
How is the house protected while the chimney is open?
We seal the fireplace opening, protect the roof and the ground below and cover the open chimney at the end of each work day. That keeps rain and debris out of the flue and the house.
Do I need an engineer before the chimney is rebuilt?
Only when the damage suggests a structural cause, such as a stack pulling away from the house, stepped cracking or signs the base has moved. We explain when that assessment should come first.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo