Chimney rebuild work from removal to crown in Hillsboro Beach
If removal shows damage lower down, we stop and show you before the boundary moves.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Clues that the stack needs reconstruction
- A gap widening between chimney and wall
- Mortar washed out deep in the joints
- Top courses shifted out of line
- Brick falling onto the roof
Jump to
A rebuild contractor that sets the boundary first
When an engineer should look first
The brick industry's maintenance guidance treats some conditions as structural rather than routine. Cracks through several units, stepped cracks, widespread broken brick, rust building up on steel in the masonry and walls pushed out of line are among them.
If we see those signs, we recommend an assessment by an engineer before the rebuild is priced. Their findings can change where the rebuild starts, whether the base needs work and how the chimney is tied to the house. We can plan the rebuild around their recommendations once you have them.
Checking flue tiles before they go in
A clay flue tile hidden inside new masonry cannot easily be inspected or replaced. The brick industry's guidance calls for inspecting flue tiles for cracks and other damage just before installation.
We check each tile as it arrives and again before it is set. A damaged tile is set aside rather than built in, and a replacement is ordered. It is a small step, but it protects the whole rebuild, since a cracked lining can let heat and exhaust reach the masonry and the house.
The code's height rule for the top
A chimney top has to clear the roof where it passes through, and it has to clear any part of the building close by. Florida's building code sets both margins. Those margins are set for fire safety rather than for draft.
When a chimney is rebuilt, the new top has to meet that rule. We check the old height against it before work starts. If the old top fell short, we explain what the rebuild must change and how the chimney will look afterwards. That way there are no surprises when the new courses go up.
A rebuild raised during a home sale
A home inspection sometimes recommends that a chimney be evaluated for rebuilding. That note rarely says how much of the chimney is affected or what the work would include.
We look at the chimney and explain whether a rebuild is warranted, how far it would go and what it would include. Each stage is priced separately, which helps buyer and seller discuss it. Once the work is done, the written record can travel with the sale paperwork. We can also explain the findings to the other party's contractor if you wish.
How a chimney rebuild is itemized in Hillsboro Beach
- Fireblocking where the stack passes floors
- Scaffold or roof staging
- Debris removal and haul-away
- Shoulders laid to shed water
Asked often about chimney rebuilds
Is a partial rebuild enough for my chimney?
Often, yes. Damage is usually worst above the roof, where the weather hits hardest. If the masonry below is sound, rebuilding only the damaged top section is the normal approach, and we explain why.
When can the fireplace be used after the rebuild?
Once the new mortar and crown have cured. The waiting time depends on the materials and the manufacturer's instructions, and we give you the timing in the written record of the work.
Is there a discount if I book the rebuild soon?
Yes. Once the free inspection at your home is done, you have 72 hours in which any service you book carries a 10% discount. The rebuild scope stays exactly as written either way.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo