Chimney rebuilding for homes in Homestead Base
We take the damaged section down to sound masonry and rebuild it with a new top and flashing tie-in.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a rebuild enters the conversation
- Broken brick spread over large areas
- Flue tiles showing through open joints
- Stepped cracks down the stack
- Masonry too loose to hold new flashing
Jump to
Chimney rebuilding in Homestead Base, step by step
What lies under a full-height rebuild
A masonry chimney stands on its own footing, and the Florida Building Code sets out how that footing is built. For a partial rebuild above the roof, the footing is rarely part of the question.
For a full rebuild, or where the whole stack has moved, the footing matters. It sits below ground and cannot be seen on a normal visit. We explain what the visible signs suggest about it and whether an engineer should assess it before the rebuild is planned. Building new masonry on a base that is still moving would not last.
Rebuilding a chimney with more than one flue
Some chimneys carry separate flues for a fireplace and another appliance, or for two fireplaces. In a rebuild, each flue keeps its own lining and stays separate from the next as the courses rise.
Tell us what each flue serves. The lining choice can differ between flues, since each must suit its own appliance. We plan the new top so every flue ends properly under the crown and cap. The estimate lists each flue separately, so nothing is assumed about the one you use less.
Saving sound bricks from the old stack
Original bricks from the dismantled section can often be reused. Each one is cleaned of old mortar and checked for cracks, broken faces and softness. Only sound units go back into the new work.
Reused brick helps the rebuilt section blend with the masonry below. It is more work than laying new brick, since each unit must be cleaned and checked, and the estimate reflects that. Where there are not enough sound units, we mix in new or salvaged brick and explain where they will sit.
Planning a rebuild around the weather
A rebuild involves several steps that depend on the weather: removal with an open top, laying brick and mortar, and casting or setting the crown. Heavy rain can stop work or damage fresh material.
We plan each step for suitable conditions and keep the open chimney covered overnight and during breaks. Moving a step to a better day does not change the scope or the price. We tell you which steps are weather-dependent so you know why the schedule may shift.
How a chimney rebuild is itemized in Homestead Base
- Rain cap fitted to the flue
- Counterflashing set into new joints
- Written record of the rebuilt section
- Mortar smears cleaned from finished brick
Chimney reconstruction questions answered
Will the rebuilt section match the rest of the chimney?
We aim for a close match in brick, mortar color and joint finish, and show you samples before work starts. New work often looks brighter at first and blends in as it weathers.
Does the rebuild include a new crown and cap?
A rebuilt top normally gets a new crown, sloped with a drip edge and a bond break around the flue lining. A rain cap is fitted or refitted to suit the flue, and both appear on the estimate.
Can I use the fireplace while the rebuild is under way?
No. The fireplace stays out of use during the rebuild and while the new masonry cures. We tell you when it can be lit again, based on the materials used and the weather.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo