Chimney rebuilds and flue decisions in Little Gables
Same-day visits are available when the schedule allows, to make loose masonry safe ahead of a rebuild.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Damage that points toward a rebuild
- A stack that has tipped out of plumb
- Mortar washed out deep in the joints
- Brick falling onto the roof
- A bulge in the chimney face
Jump to
How a chimney rebuild comes together
Why a rebuild instead of another repair
A rebuild becomes the sensible choice when the damage is too deep or too widespread for local repairs to hold. Loose units running through several courses, mortar that has turned to sand and a top that has shifted out of line are common reasons.
We do not suggest rebuilding because a chimney looks tired. The estimate explains what we found, why repointing or replacing individual bricks would not last and how far the damaged section extends. If a smaller repair would do the job, we say so and price that instead.
A formed crown with an overhang
The brick industry's chimney guidance favors a precast crown or a cast-in-place crown shaped like one, with thickened edges and an overhang past the brick. The overhang keeps rain off the top courses and throws it clear of the face.
We describe the crown's form on the estimate: how it is made, how it sheds water and how it sits over the new masonry. Where a precast crown suits the chimney, we explain the choice. Either way, the finished crown is sloped, overhangs the brick and carries a drip edge.
Same-day make-safe work, when the schedule allows
When a chimney top is loose or has partly fallen, a quick visit to make it safe matters most. Same-day visits are available when the schedule has room for one. On that visit, masonry at risk of falling is taken down and the opening is protected.
The rebuild itself follows once the scope is agreed and materials are ready. Both the make-safe visit and the rebuild are priced separately, and each waits for your approval. Sound bricks taken off during the make-safe step are kept for reuse.
A bulge in the chimney face
A face that bulges outward means the masonry has moved out of line. The brick industry lists masonry pushed out of plane among the signs of a structural problem, not routine wear.
A bulging section cannot be pushed back into place, and repointing it only fills its joints in the wrong position. We explain how far the bulge extends and whether rebuilding that section, and assessing its cause, is needed. Keep clear of the area below in the meantime. The estimate records where the bulge sits and how far it runs.
Items in a rebuild above the roofline
- New brick matched to the lower courses
- Counterflashing set into new joints
- Structural assessment flagged where needed
- Mortar smears cleaned from finished brick
What people ask before a rebuild
What does the workmanship warranty cover on a rebuild?
It stands behind the rebuild work we agreed and completed: the relaid masonry, the crown and the parts we installed. Retained masonry below the boundary and work by other trades fall outside it.
How do you keep debris off the roof and the yard?
Masonry is taken down by hand and lowered in a controlled way. We protect the roof covering and the ground below, clean up as we go and haul all of the debris away at the end.
Do you need to go into the attic for a rebuild?
Sometimes. If removal goes below the roof line, the attic side shows the masonry, the framing clearances and the fireblocking. We tell you in advance if attic access is part of the plan.
More Ways to Care for Your Fireplace
- Chimney Cap Installation and ReplacementProtect the chimney opening with a cap chosen for its fit, attachment and compatible system.
- Chimney Damper Repair and ReplacementRestore a usable damper mechanism after checking the plate, frame and control linkage.
- Gas Fireplace Repair and ServiceGet a model-specific gas fireplace service plan for the fault you are seeing or the maintenance your unit needs.
- Top-Sealing Damper InstallationFit a top-mounted damper only after checking the fireplace, product restrictions and control route.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo