Chimney rebuilds and flue decisions in Poinciana Park
A rebuild starts with a clear removal boundary, agreed with you before any brick comes down.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Damage that points toward a rebuild
- A stack that has tipped out of plumb
- A gap widening between chimney and wall
- Broken brick spread over large areas
- Stepped cracks down the stack
Jump to
How a chimney rebuild comes together
Keeping the stack's shape where it meets the roof
Close to a floor, ceiling or roof crossing, the code keeps a chimney wall and its flue lining at one size and shape. The rule covers a short zone just above and just below each crossing.
When a rebuild starts near the roof line, we keep the new courses in line with the masonry below through that zone. Any decorative change in the top's shape comes higher up, where the code allows it. The estimate describes the shape of the rebuilt top in words.
Building the new walls solid
Every new course in a rebuild follows the code's rule for chimney walls. Solid units are used, or hollow units with their cells grouted full.
Behind the face, the new work is laid with full joints so there are no voids for water to move through. That hidden part of a rebuild is easy to skip and hard to check once finished. We describe the wall construction on the estimate so you know what is inside the new masonry, not only what shows.
Protecting the roof during removal
Taking masonry down means heavy material moving above the roof covering. Dropped brick, tool marks and foot traffic can crack or scuff some coverings.
We plan how the masonry comes down and where it goes, protect the roof around the chimney and keep traffic to set routes. Let us know the roofing material and any spots that are already cracked or loose. Any roofing that must be lifted is named on the estimate, along with who resets it. If the covering is easily damaged, we may suggest the roofer lifts and resets it.
Where the new masonry meets the old
The join between rebuilt courses and retained masonry is the most visible line on a partial rebuild. A clean, level transition with matching joint lines makes it read as one chimney.
We set the first new course carefully on the prepared old masonry and carry the joint lines through. Some difference in color is likely at first, since the old brick has weathered. We explain what to expect before you approve and how the contrast usually softens over time. Where the join falls at the roof line, the flashing often hides much of it anyway.
Items in a rebuild above the roofline
- Debris removal and haul-away
- Fireplace opening sealed during removal
- Written record of the rebuilt section
- Sample panel for brick and mortar
Questions people raise about a rebuild in Poinciana Park
Do I need an engineer before the chimney is rebuilt?
Only when the damage suggests a structural cause, such as a stack pulling away from the house, stepped cracking or signs the base has moved. We explain when that assessment should come first.
Is there a discount if I book the rebuild soon?
Yes. Once the free inspection at your home is done, you have 72 hours in which any service you book carries a 10% discount. The rebuild scope stays exactly as written either way.
Do you need to go into the attic for a rebuild?
Sometimes. If removal goes below the roof line, the attic side shows the masonry, the framing clearances and the fireblocking. We tell you in advance if attic access is part of the plan.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo