
Chimney rebuilding for homes in Virginia Gardens
If removal shows damage lower down, we stop and show you before the boundary moves.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a rebuild enters the conversation
- Top courses shifted out of line
- Daylight through the masonry in the attic
- Brick falling onto the roof
- Stepped cracks down the stack
Jump to
A rebuild contractor that sets the boundary first
Checking flue tiles before they go in
A clay flue tile hidden inside new masonry cannot easily be inspected or replaced. The brick industry's guidance calls for inspecting flue tiles for cracks and other damage just before installation.
We check each tile as it arrives and again before it is set. A damaged tile is set aside rather than built in, and a replacement is ordered. It is a small step, but it protects the whole rebuild, since a cracked lining can let heat and exhaust reach the masonry and the house.
Where new lining meets the old
In a partial rebuild, the new flue lining must meet the lining that stays below. Code rules for clay linings expect them to run from the top of the smoke chamber, or from below the lowest inlet, to a point above the chimney's enclosing walls.
Where old and new tiles meet, the joint has to be sound and smooth on the inside. If the retained lining is damaged, a rebuild does not fix it by itself. We check the lining below the rebuild line where we can and tell you whether it needs its own repair.
Rebuilding a chimney with more than one flue
Some chimneys carry separate flues for a fireplace and another appliance, or for two fireplaces. In a rebuild, each flue keeps its own lining and stays separate from the next as the courses rise.
Tell us what each flue serves. The lining choice can differ between flues, since each must suit its own appliance. We plan the new top so every flue ends properly under the crown and cap. The estimate lists each flue separately, so nothing is assumed about the one you use less.
Fireblocking at floors and ceilings
At each floor and ceiling a chimney passes, the code requires the gap between chimney and framing to be closed with noncombustible material fastened in place. That fireblocking keeps fire and hot gases from traveling through the gap.
When a rebuild goes below the roof line, we check the fireblocking at each level we reach. Missing or combustible material is replaced as part of the work or noted for the right trade. The estimate lists the levels where fireblocking is checked or installed.
Line items in a chimney reconstruction
- New brick matched to the lower courses
- Rain cap fitted to the flue
- Top height checked against the code
- Structural assessment flagged where needed
Before you approve a chimney rebuild
When can the fireplace be used after the rebuild?
Once the new mortar and crown have cured. The waiting time depends on the materials and the manufacturer's instructions, and we give you the timing in the written record of the work.
What should I have ready before the rebuild visit in Virginia Gardens?
A way into the room with the fireplace, a route to the part of the yard under the chimney and, if possible, attic access. Records of earlier repairs and any roof plans help us set the boundary and the order of work.
How do you keep debris off the roof and the yard?
Masonry is taken down by hand and lowered in a controlled way. We protect the roof covering and the ground below, clean up as we go and haul all of the debris away at the end.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo
