Restore a damaged chimney in Coral Ridge
Water, heat and movement damage a chimney in different ways, so we name the cause before we suggest a repair.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Where chimney damage tends to surface
- Brick pieces on the roof or patio
- Damp patches near the fireplace wall
- Flakes or grit falling into the firebox
- A gap between chimney and house wall
Jump to
Chimney damage explained before it is repaired
Fire and alarms first, chimney repairs after
A fire in the chimney, smoke spreading through the rooms or a sounding carbon monoxide alarm is not a repair question. Get every person and pet out of the house first. From the yard, call 911 and wait there until the responders say it is safe to go back in.
Chimney damage that cannot wait, but is not a fire, is a different case. Masonry dropping toward a walkway or water pouring in beside the chimney in a storm are examples. For those, our 24/7 emergency line takes the call, and the lasting repair is planned once the immediate risk is under control.
The metal rain cap and the masonry top differ
The metal hood that sits over the flue opening is a rain cap, a different part from the masonry crown beneath it. It keeps rain and debris out of the flue, and the code expects any rain cap to leave enough open area for the chimney to vent properly.
A cap can rust, loosen in the wind or clog with debris. Swapping the cap leaves a cracked crown just as it was, so the two parts are assessed side by side. When the cap includes a spark screen, the code calls for a mesh that resists heat and corrosion and can be removed for cleaning. The screen also has to stay clear enough for smoke to pass.
White deposits on the chimney face
A white powder or crust on brick is usually efflorescence. It forms when water moving through the masonry carries dissolved salts to the surface and then evaporates. The deposit itself is mostly cosmetic, but it shows that water is traveling through the chimney.
Cleaning it off without stopping the water only buys time, because the deposit returns once the masonry gets wet again. We trace the source first, which may be the crown, the cap, a joint or the roof junction. After the cause is fixed and the brick has dried, gentle cleaning usually removes what remains.
Cracks near the footing of a chimney
Masonry chimneys stand on their own concrete or masonry footings. Cracks that start low and climb, or a base that has dropped against the house wall, can point to a problem with the footing below.
That part is buried and cannot be seen during a normal visit. We describe what the visible cracks suggest and whether a structural assessment is needed before repairs above are priced. Patching the stack while the base continues to move would not last. The estimate keeps that assessment as its own step, ahead of any masonry work.
Repair lines for a damaged chimney
- Water repellent after masonry repairs
- Removal of failed sealant patches
- Stucco crack routing and patching
- Roof access and roof covering protection
Chimney damage questions from Coral Ridge
How do you protect the roof and yard during chimney work?
We plan access to limit foot traffic on the roof covering and protect the areas below the chimney. Mention planting beds, a pool deck or fragile paving when you book so protection is part of the plan.
Can you tell whether water comes from the chimney or the roof?
Often, yes. We look at the flashing, the top of the chimney and the roof covering nearby. Where the source is still unclear, a hose water test on one area at a time can separate them.
Can you repair a chimney that also vents a furnace or water heater?
Yes, with planning. If the repair would interrupt that vent, the appliance may need a heating or plumbing contractor to disconnect and reconnect it, and we build that step into the schedule.
More Ways to Care for Your Fireplace
- Chimney Damper Repair and ReplacementRestore a usable damper mechanism after checking the plate, frame and control linkage.
- Chimney Animal RemovalAssess occupied chimney openings and plan appropriate follow-up cleaning or entry protection.
- Chimney Flue RepairAssess repairs to damaged existing flue linings and distinguish them from a new liner installation.
- Stone Chimney RepairRepair affected stone chimney surfaces with the supporting construction and visual match considered together.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo