Skip to content
(645) 465-4171

Chimney restoration, planned part by part, in Country Walk

Repairs you book within 72 hours of your free inspection come with 10% off, and the scope stays the same.

  • Owned and run locally
  • Available for same-day service
  • Fully licensed and insured
  • Family owned and run

Marks that point to chimney damage

  • Smoke that drifts back into the room
  • Lifted metal where chimney meets roof
  • Water dripping onto the damper
  • Old patches that keep failing
Jump to

Chimney damage, the causes and the repairs

Hose testing a leak one area at a time

Some leaks are hard to trace from the inspection alone. When the job calls for it, we may run a hose water test. Water goes onto a single section of the chimney while a second person watches the ceiling or wall indoors. Starting low and moving up separates one possible entry point from the next.

The test is a diagnostic step, not a routine part of every visit. We explain before we start which parts will be wetted and what we hope to learn. If the test points to one entry, that result goes into the scope. Where it makes sense, a repeat test after the repair confirms the fix.

Chimney work before a new roof goes on

A roof replacement is a good moment to deal with the chimney. The flashing at the junction often gets replaced with the roof, and masonry repairs above it are easier before new roofing is laid around the base.

If a new roof is planned, tell us the timing and the roofer's scope. We look at the chimney first, so masonry and top repairs can be finished before the new covering goes on. That order avoids opening fresh roofing later to reach a chimney problem that was already there.

An unused flue still has a top

A flue that no longer serves an appliance still ends at the top of the chimney, and rain can still enter it. If it was left open, water and debris may be collecting inside.

We look at how an unused flue was closed off, if at all. Options depend on whether you may want to use it again. We explain those options and what each one leaves in place, so the choice is yours rather than something decided for you during another repair.

Damage that goes past a local repair

A few loose bricks near the top can be reset. When loose masonry runs several courses deep, when earlier repairs keep failing or when the stack has moved, a local repair may not hold for long.

At that point we explain what the evidence shows and where sound masonry seems to begin. Chimney rebuild covers taking the damaged section down to that point and relaying it. You see both options side by side, with the reasons for each, before choosing.

Chimney damage repair items we price

  • Replacement of spalled brick units
  • Smoke chamber surface assessment
  • Stucco crack routing and patching
  • Connected appliance vent noted and protected

What people ask about chimney damage

Do I need to know which part is damaged before I call?

No. Describe what you saw, where you saw it and when it started. A stain, a fallen piece of brick or a loose cap is enough for us to plan the visit and bring the right equipment.

Should I keep using the fireplace until the chimney is repaired?

That depends on what was found. If we advise you to stop, keep the fireplace out of use until the repair is complete. Damage that is only cosmetic may not affect use, and we tell you which case applies.

Should chimney repairs wait until after a planned new roof?

It is better to plan them together. Masonry and flashing work at the roof junction often ties into the new covering, so we agree the sequence with your roofer before either job starts.

Proudly American

Local service. Careful repairs. A fireplace worth coming home to.

Call Now (645) 465-4171

Book Your Free Inspection in Miami

(645) 465-4171

Send your details for a free Miami chimney or fireplace inspection. We will call to confirm the appointment.

Chimney & Fireplace Brands We Work With