Chimney restoration, planned part by part, in Kendale Lakes
From the top of the stack to the firebox, we separate what needs repair now from what can wait.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Where chimney damage tends to surface
- Damp patches near the fireplace wall
- Flakes or grit falling into the firebox
- Plants rooting in the chimney joints
- Old patches that keep failing
Jump to
Chimney damage explained before it is repaired
Paint and film coatings on chimney brick
Some chimneys have been painted or coated with a film that sits on the surface. A film can hold moisture inside the brick instead of letting it dry outward. Trapped water can then push the coating off, sometimes with the brick face attached.
If your chimney has a coating that is peeling, blistering or darkening in patches, mention it when you book. We look at what lies beneath the failing areas and whether the coating is part of the problem. Removing or replacing a coating is its own decision, separate from the masonry repair, and it is priced that way.
An unused flue still has a top
A flue that no longer serves an appliance still ends at the top of the chimney, and rain can still enter it. If it was left open, water and debris may be collecting inside.
We look at how an unused flue was closed off, if at all. Options depend on whether you may want to use it again. We explain those options and what each one leaves in place, so the choice is yours rather than something decided for you during another repair.
Exhaust that condenses inside the flue
A furnace or water heater that vents into a masonry chimney sends warm, moist exhaust up the flue. If the flue is too large for that appliance or the lining is damaged, the exhaust can cool and condense before it leaves. That moisture carries acids into the mortar and brick.
Signs include staining low on the chimney, crumbling joints near the top and debris at the base of the flue. The Florida Building Code's fuel gas volume sets how gas-fired appliances vent into chimneys. We point out when a venting question needs the appliance installer and keep the masonry repair as its own line.
When another trade is part of the job
Some chimney repairs touch work that belongs to other trades. A roofer may need to reset the covering around the chimney. An electrician may need to move a wire, and a plumbing or heating contractor may need to disconnect an appliance vent.
We tell you which parts of the job need someone else and when in the sequence they fit. The estimate lists our work and names the other trade's step, so nothing is assumed. If you already work with a roofer or contractor, we are glad to coordinate with them directly.
Repair lines for a damaged chimney
- Damper plate and handle repair
- Debris cleanup and haul-away
- Written record of the completed work
- Check of anything fastened to the chimney
Chimney damage and repair, common questions
Should I keep using the fireplace until the chimney is repaired?
That depends on what was found. If we advise you to stop, keep the fireplace out of use until the repair is complete. Damage that is only cosmetic may not affect use, and we tell you which case applies.
How do you protect the roof and yard during chimney work?
We plan access to limit foot traffic on the roof covering and protect the areas below the chimney. Mention planting beds, a pool deck or fragile paving when you book so protection is part of the plan.
When would an engineer need to look at my chimney?
Signs such as cracks running through several bricks, stepped cracking, a stack pulling away from the house or widespread broken brick can point to a structural cause. We tell you when that assessment should come before repair.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo