
Clean flues and clear findings for Lauderhill chimneys
A local team that cleans what it can reach and says so plainly where it cannot.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What prompts a chimney cleaning call
- The damper will not close fully
- Fires that are slow to draw
- Sticky residue around the damper frame
- Soot appearing when exhaust fans run
Jump to
Soot removal and findings, kept separate
How the room is protected while soot comes loose
Protection goes down before any deposit is disturbed. The hearth, the floor in front of the opening and the route in and out are covered. The fireplace opening is then closed off so that loosened soot drops into the firebox and not into the room.
Tell us about finishes that mark easily, such as pale stone or a textile rug near the hearth. Where the surround has a delicate face, we plan how the covers are held so they do not scuff it. At the end, covers are lifted slowly and folded inward to keep residue contained.
Brushing the flue walls along their length
The flue is the passage that carries smoke out of the house, and most of the soot sits on its walls. Rods and a brush sized to the flue are run through the full length that can be reached. The brush has to fit closely enough to scrape the walls without jamming at joints or bends.
A round flue and a rectangular one need different brush shapes. A metal liner calls for a brush that will not scratch its surface, as listed chimney instructions note. We choose the brush after identifying the lining, not before, and explain the choice if you ask.
The workmanship warranty on cleaning work
Cleaning is work like any other, and it is backed by our workmanship warranty. The written record says what we did, and the warranty applies to that work. Keep it with your other fireplace papers.
Suppose a part we handled, such as a damper we freed or a cap we refitted, does not work as it did before. Tell us promptly, and we look at it again under the warranty. Conditions we recorded but were not asked to repair are not part of that promise, which is why the record separates them.
Cleaning the flue after an animal has left
Once an animal has gone and the flue can be worked on, what it left behind still needs removing. Nest material, droppings and debris can block the passage and hold odor. They are also combustible, so they should not be left for the next fire to find.
We bag the material with care, keeping it contained in the firebox, and brush the flue and smoke shelf clear. If the entry point is still open, we note it so the problem does not repeat. The written record lists what was removed and what the top needs.
Items in a chimney cleaning visit
- Flue brushing along the reachable length
- Identification of each flue and opening
- Cleanout opening emptied where present
- Throat cleared of soot and flakes
Before you arrange a chimney sweep
Can you remove a bird nest during a chimney cleaning?
Not while it is active if the birds are protected. We identify what is there before any brushing. Once the flue is empty and can lawfully be worked on, the nest material comes out as part of the cleaning.
Do you clean metal factory-built chimneys?
Yes. We identify the brand and follow its cleaning instructions. They say which brush materials suit the metal flue and how the cap comes off. Repairs to damaged sections have to use the manufacturer's listed parts.
Does the booking discount cover a chimney cleaning?
Yes. A cleaning approved inside 72 hours of your free inspection gets 10% off. So does any other service booked in the same window. The clock starts at your own inspection.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo
