Waterproofing chimney masonry after repairs in Little River
A yes to the treatment inside 72 hours of your free inspection means 10% off that work.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What absorbent chimney brick looks like
- Brick that stays dark long after rain
- Glossy patches from an earlier coating
- Brick grit collecting on the roof below
- Hairline gaps between brick and mortar
Jump to
Waterproofing work for chimneys in Little River
Paint and clear repellents do not mix
A clear penetrating repellent is made for bare masonry. Product data rules out painted surfaces, because the treatment cannot reach the pores through paint. On a painted chimney, a repellent would sit on the paint and do little.
If your chimney is painted, the choices are different. The paint itself may need attention, or it may be fine as it is. We explain what we see and whether any treatment is sensible. Removing paint to allow a repellent is a separate job with its own risks, and we discuss it before recommending it.
When treatment may not be needed
A well-built chimney in sound condition may not need a repellent at all. Brick industry guidance notes that good materials, detailing and maintenance usually give water resistance without one. Treatment is most useful where brick is absorbing more water than it should.
We tell you honestly if we do not think treatment is worth it on your chimney in Little River. If the masonry is sound and the top and the roof junction are tight, the money may be better spent elsewhere or not at all. You decide, with the reasons in front of you.
Why chimneys get wetter than walls
A chimney stands above the roof with no eaves or overhangs to shelter it. Rain hits every face, and water that lands on the top runs down the sides. Brick industry guidance names chimneys among the masonry most exposed to water.
That exposure is why chimneys are one of the places a repellent can make sense, once repairs are done. It is also why the top matters so much. A chimney that sheds water from its top and roof junction gives any treatment on its faces a much easier job.
What happens on the application day
On the application day, we confirm the forecast, check that the masonry is dry and set up access. Glass, metal, roofing and plants in range are covered or masked. Cars and furniture have been moved.
The product then goes on, face by face, by the method its data sheet sets. Overspray is dealt with as the work proceeds. When the product has set enough, coverings come off and the area is cleaned. We go through what was treated and hand over the written record.
The water repellent scope, face by face
- Mortar joints checked for gaps and softness
- Cap or open flue noted at the top
- Glass and skylights masked
- Nearby vents and intakes covered
Repellent and sealing questions from Little River
Can a repellent close cracks in the brick or the joints?
It cannot. Penetrating repellents work inside the pores, and anything wider than a fine hairline is beyond them. Open joints are repointed, cracked units replaced and gaps sealed before treatment. We list those repairs separately, with the reason for each.
How long should new mortar cure before the treatment?
The product data decides, together with the mortar used and the weather. New work often needs cleaning before treatment as well. We schedule the repellent as its own step after the repairs, so it is not rushed onto fresh joints.
How will I know if the treatment is still working?
Look at the chimney during and after rain. Treated faces should shed water and dry evenly. If a face darkens and holds water again, the treatment may be fading or something else has changed. A maintenance visit can check it and the parts it depends on.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo