Worn firebox repair for wood fireplaces in Lighthouse Point
The chamber that takes the fire is repaired with materials that can take it, joint by joint.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What cracked or loose firebrick looks like
- Crumbling faces on the back wall
- Cracks running through a firebrick
- Grit falling from the firebox walls
- Rust streaks on the upper back wall
Jump to
Local firebrick repair or a full firebox rebuild
Workmanship warranty on the firebox repair
Our workmanship warranty covers the firebox repair we carry out. It applies to the units we set and the joints we filled, used as the fireplace is meant to be used and cured as the product directions require.
Damage from overfiring, water from an unrepaired leak or parts of the firebox outside the repaired area fall outside it. We explain those limits when the job is finished, and the written record of the work shows what the warranty covers. Keep the record with your fireplace papers, so the covered work is easy to identify.
Corners where the side walls meet the back
The inside corners of the firebox are where two walls, and their movements, meet. Joints there often open before the flat faces of the walls do, and the units at the corners are the first to loosen. Movement at a corner also shows up as a crack that climbs in a stepped line.
We check each corner from floor to top course. Repointing an open corner joint is a small repair when caught early. Where corner units have shifted, we reset them so both walls bear evenly again, and the estimate names each corner that is included.
Seen and hidden on a firebox visit in Lighthouse Point
On a firebox visit in Lighthouse Point, we see the face of the lining, the joints, the floor and the damper seat. The backup masonry, the space behind the lining and the base under the floor stay hidden.
We tell you which of those we could not examine and whether anything suggests trouble there. If a closer look is needed, it is priced as its own step. Most firebox repairs go ahead without it, and we say plainly when that is the case.
Firebrick in factory-built units in Lighthouse Point
In Lighthouse Point homes, certain factory-built wood fireplaces use the maker's firebrick rather than panels. We read the label and the manual, then order the listed firebrick for that model. Those bricks are part of the unit's listing, so generic firebrick is not a substitute.
Replacement bricks go back in the positions the manual shows, set the way it describes. If the unit uses panels instead, we route the job to our prefab fireplace repair service and explain why. Where the maker no longer supplies the brick, we tell you before any work begins and explain the options.
Firebrick work listed line by line
- Loose and cracked units marked
- Ash dump frame reset where present
- Old brick and mortar hauled away
- Grate condition noted
Firebrick replacement questions, answered
How soon can I light a fire after the firebox repair?
That depends on the product used. Most refractory mortars need drying time and then a heat cure that starts with a small, low fire. We give you the steps in writing before we leave.
Do factory-built fireplaces ever use firebrick?
Some factory-built wood units are lined with the maker's firebrick, placed as the manual shows. Replacements come from the maker's parts list for that model. Others use panels, which go to our prefab repair service.
Do you arrange firebox repair throughout Lighthouse Point?
Yes. We book a free inspection at a time that suits you, identify the lining and explain the findings. A free written estimate follows, and work starts only after you approve it.
More Ways to Care for Your Fireplace
- Chimney Flashing RepairRepair the chimney-to-roof connection with a scope that accounts for the adjoining roofing and masonry.
- Gas Fireplace VentingAssess and repair the gas fireplace vent arrangement using components suited to the identified system.
- Chimney Crown RepairRepair the damaged chimney top with an approach matched to the crown and supporting masonry.
- Stone Chimney RepairRepair affected stone chimney surfaces with the supporting construction and visual match considered together.
- Fireplace Hearth RepairRepair the hearth surface after considering the supporting assembly and fireplace requirements.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo