Your masonry fireplace, fitted with a wood insert in Miramar
Wood inserts that meet EPA 2020 emission limits, installed with the clearances and hearth protection their manuals set.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Problems a new wood-burning insert can address
- Little warmth from an open fire
- A worn insert with a warped door
- Drafts from an open damper
- An old insert without its manual
Jump to
Turning a masonry fireplace into a wood insert host
No connection to heating or cooling ductwork
Insert manuals warn against connecting the unit to any air distribution ductwork unless the manual specifically approves it. The insert is a room heater, and its combustion gases and heat belong in the liner and the room, not in the home's duct system.
We check that nothing ties the insert to the heating and cooling system. If someone has suggested routing warm air from the insert elsewhere, we explain what the manual allows. Anything beyond that stays out of the installation, and the record says so.
Fitting the faceplate before the unit goes home
Some manuals require the faceplate panels to be attached to the insert before it slides into final position and connects to the liner. Other trim pieces follow once the connection is made. The order matters, because some panels cannot be reached after the unit is in place.
We follow the sequence your insert's manual gives. The unit is eased into place without disturbing the liner connection, then the remaining trim goes on. Clearances to combustibles are checked again once everything is fitted.
Blower habits when the door opens
One maker's manual says the blower must be switched off whenever the fuel door is opened. Before switching it back on, you check that no embers have dropped onto the hearth near the blower. It is a small habit that the manual treats as important.
We explain the blower controls at handover, including the automatic setting where the model has one. Some blowers switch on as the insert warms and off as it cools. Knowing how yours behaves makes it easier to follow the manual's advice.
Keeping the insert glass clear
Glass on an insert stays clearer when the fire burns hot enough and the wood is dry. Many inserts send a wash of air down the inside of the glass to help. Dark, heavy deposits on the glass usually mean the fire is too cool or the fuel is wet.
Clean the glass only when the insert is cool, and use a non-abrasive cleaner as the manual advises. Abrasives can scratch the ceramic surface. If the glass darkens quickly despite dry wood, ask us to look at the air settings and the draft.
Priced separately for a fireplace insert
- Host fireplace condition check
- Air control and blower walkthrough
- Separate pricing for insert and liner
- Manual and listing details handed over
Questions about fireplace insert installation in Miramar
Do I need a liner all the way to the chimney top?
Current insert manuals call for a continuous liner from the insert's collar to the top of the chimney. The old masonry flue then encloses the liner rather than carrying the smoke. We include the liner as part of the installation, not as an extra.
How do I know the insert meets current emission limits?
The label on the insert shows the standard it meets. Current wood inserts carry a label stating that they meet the EPA 2020 emission limits. We show you the label on your model and keep its details in the written record.
How often does an insert need a maintenance visit?
It depends on how much and how you burn. Manuals ask for regular checks of the chimney connector and liner during the burning season. Our maintenance visits cover the liner, cap, baffles, gasket and glass.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo