Factory-built or masonry fireplaces, installed in Hialeah Gardens
We explain each decision before you approve it, from the model and hearth to the chimney termination.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Reasons people plan a fireplace installation in Hialeah Gardens
- Smoke rolling out of an old unit
- Old chimney pipe with separated joints
- A fireplace that cannot be repaired safely
- No outside air for the fireplace
Jump to
Fireplace installation choices explained for Hialeah Gardens homes
Steel fireplace units inside masonry
The code allows a steel fireplace unit to be encased in solid masonry to form a masonry fireplace. It can follow its own listing or the code section written for these units, which sets steel thickness and masonry cover. Some of these units circulate warmed room air through ducts.
If this hybrid appeals to you, we explain how it differs from an all-brick firebox and from a fully factory-built unit. The circulating ducts must be metal or masonry. We only propose it when the unit's instructions and the masonry plan match.
Signs a factory-built unit has reached its end
Warped or burned-through firebox metal, rust holes in the outer casing and chimney sections that have separated all point to a unit near the end. So does a model whose maker no longer supplies refractory or chimney parts. Operating a damaged unit is something the manuals prohibit.
Tell us what you have seen and how the fireplace has behaved. We confirm the condition during the free inspection and explain which findings are cosmetic and which affect safety. The decision to replace comes from those findings, not from the age of the unit alone.
Burning the right wood in a new fireplace
A new fireplace performs best with dry, split, seasoned wood. The EPA's wood-burning guidance says a properly installed appliance should make very little smoke, and regular visible smoke points to a problem. Wet wood is a common one. Wood dries better stored off the ground with only its top covered.
We explain how to tell dry wood from wet wood and why treated lumber, painted scraps and trash stay out of the firebox. Those materials can release harmful fumes and damage the unit. Good fuel keeps the new chimney cleaner between maintenance visits.
Running the chimney out through a wall
Some layouts send the chimney through an exterior wall with listed offset parts, then up the outside of the house in a chase. Manuals show this as a recognized arrangement, with the same clearance and firestop rules inside the wall. It can free the room above from a chimney path.
We explain when this route suits your floor plan and what it adds outside. The chase then needs its own framing, cladding and top. We compare it with a straight interior path so you can see the trade before choosing.
Checked and written down before installation starts
- Structural support for chimney sections
- Daily cover for the open roof penetration
- Written record of the completed installation
- Grate, screen and supplied accessories check
Your new fireplace installation, in questions
Which suits my house, a factory-built or a masonry fireplace?
It depends on the structure, the room and how you plan to use the fire. Masonry needs a footing and more time, while a factory-built unit is framed in and follows its listing. We explain both for your house after the inspection.
Who handles the wiring for a blower or fan kit?
An electrician. We place the electrical box where the manual shows while the framing is open, and the electrician runs any new circuit under the electrical code. The estimate shows that work as a coordinated item.
Do you set the tile or stone around the opening?
Only if the estimate names it. Often the finish belongs to a tile setter or mason. Either way, we mark the noncombustible zones and the mantel limit so whoever sets the finish works to the manual.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo