Wood fireplace installation and chimney planning in Melrose Manors
Book the agreed installation no later than 72 hours after your free inspection and save 10% on it.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What starts a fireplace installation project in Melrose Manors
- A room with no fireplace yet
- An old unit that fails its listing
- Missing parts nobody can identify
- An enclosure too small for newer units
Jump to
Installation decisions for a wood fireplace in Melrose Manors
Picking the roof exit for the chimney
A chimney that exits near the highest part of the roof deals with less wind interference. Manuals also ask for the termination to stay clear of trees, taller walls and uneven roof lines. Those recommendations can shift the ideal position for the fireplace inside the room.
We look at the roof from outside and from the attic before settling the location. If a nearby roof section sits higher than the planned exit, the chimney may need more height or a different spot. We explain both options and what each adds to the job.
An outside air supply for the fire
The Florida Building Code asks for an exterior air supply to fireplaces unless the room is mechanically ventilated and held at neutral or positive pressure. For a factory-built unit, the duct for outside air must be a listed component installed to the maker's instructions.
We plan the outside air path together with the chimney path. It needs its own opening through a wall or into a ventilated space, and its own termination hood. The route, the hood and the damper control appear on the estimate so you can see what the supply involves.
Setting the refractory, baffle and blanket
Many factory-built wood fireplaces ship with refractory panels or loose firebrick, and some include a baffle and ceramic blanket above the firebox. The manual shows the order and position of each piece. A missing or misplaced baffle can change how the unit burns.
We set these parts as the manual shows before the first fire and note it in the handover checklist. Later, when a panel wears out, the same parts list tells you what to order. Keep that page with the manual so the replacement matches.
Hot glass and screens around children and pets
The glass, screen pulls and metal face of a factory-built fireplace get hot during a fire and stay hot while it cools. Manuals warn about this for children and pets in particular. Supervision and keeping small hands away matter more than any single part.
We point out the hot surfaces at handover and where the manual places its warnings. Keep the screen closed while the fire burns and let the fireplace cool fully before cleaning. The manual's cleaning steps assume a cold unit.
Separate items in a new fireplace proposal
- Exhaust fans and house pressure review
- Debris cleanup and haul-away
- Break-in fire guidance at handover
- Masonry chimney lining and cleanout plan
Asked before a fireplace installation in Melrose Manors
Can the chimney run up an outside wall of the house?
Yes, inside a properly built chase. Manuals ask for the chase to be framed and sealed like an outside wall, with false ceilings and firestops as it rises. The chase, its cladding and its top are priced as separate items.
What happens to the roof opening at the end of each day?
Any open roof penetration is covered at the end of every work day until the chimney is sealed. Debris is gathered daily and taken away with us once the job is complete. Tell us about anything else on the roof we should protect.
Do kitchen fans and bathroom fans affect a wood fireplace?
They can. Exhaust fans remove air from the house, and the fire needs air to replace what goes up the chimney. We review the fans and the outside air plan together, and at handover we explain how to start fires with the strongest fans off.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo