Wood fireplace installation and chimney planning in Port Royale
A free inspection in Port Royale, a written estimate with separate line items, and no hidden fees on the final bill.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a new fireplace is the right call in Port Royale
- Rusted metal inside an old fireplace
- Discontinued model with no listed parts
- Missing parts nobody can identify
- An enclosure too small for newer units
Jump to
From listing label to first fire, the installation
Map the joists before choosing the wall
A factory-built fireplace sends its chimney straight up through floors, ceilings and the attic. Where it lands relative to the joists and rafters decides how much framing must be cut and headed off. A spot a little to one side can mean far less structural work.
We check the ceiling framing and the attic along the proposed path during the free inspection. Tell us about attic access, stored items and any ductwork up there. What we find goes into the estimate as its own framing item, so you can see its effect on the plan.
Insulation kept clear inside the chase
Inside a chase, insulation and other materials must stay secured away from the chimney sections. Manuals warn that contact can overheat the surrounding material. Blocking at the right places keeps blown insulation from drifting into the chimney's air space over time.
We install that blocking and check the gaps before the chase is closed. If the chase is insulated for comfort, we confirm the batts are fastened and clear of the pipe. The finished chase then gets a final look before the cladding goes on.
Coordinating the roof opening with roofing work
Cutting a chimney through the roof affects the roof covering around it. The chimney maker's parts seal the penetration, but the surrounding tiles, shingles or membrane may need a roofer's attention. Any warranty your roofer gave on the roof is also worth checking first.
We explain which part of the roof work we complete and which part belongs to a roofer. If a roofer is needed, the estimate shows it as coordination with its own line. Scheduling the two trades in the right order keeps the opening covered and dry.
Starting fires without flammable liquids
Manuals warn against using gasoline, lantern fuel, kerosene or charcoal lighter fluid to start or freshen a wood fire. Those liquids can flash and overfire the unit. Paper, dry kindling and a pre-warmed flue do the job safely.
We show you the lighting method your manual describes, including how to warm the flue so smoke rises from the start. Keep flammable liquids and their vapors stored well away from the fireplace room. A calm start makes for a clean fire and a cleaner chimney.
The fireplace installation scope, item by item
- Floor, ceiling and attic framing check
- Chase framing for an exterior chimney
- Surrounding finish boundaries for other trades
- Masonry chimney lining and cleanout plan
What people ask about wood fireplace installation
Who handles the wiring for a blower or fan kit?
An electrician. We place the electrical box where the manual shows while the framing is open, and the electrician runs any new circuit under the electrical code. The estimate shows that work as a coordinated item.
Can the chimney run up an outside wall of the house?
Yes, inside a properly built chase. Manuals ask for the chase to be framed and sealed like an outside wall, with false ceilings and firestops as it rises. The chase, its cladding and its top are priced as separate items.
Could you install a gas or electric fireplace instead?
Those are separate services with their own rules and parts. This installation service covers wood-burning fireplaces. Tell us which fuel you prefer when you call, and we arrange the right visit and scope for it.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo