Fireplace Repair and service for Colee Hammock fireplaces
A local team that separates working faults from cosmetic ones and tells you which is which.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When fireplace repair is worth a call in Colee Hammock
- Loose or missing firebrick
- Warped metal inside the unit
- Gap between the face and the wall
- Odor from the fireplace between fires
Jump to
What goes into fireplace repair for homes in Colee Hammock
After a chimney fire or another damaging event
Manufacturer manuals and the national fireplace and chimney standard both call for a look at the system after an event likely to have damaged it. Warped metal, cracked panels, a loosened firebox or smoke staining in odd places can all follow. Do not relight until that look has happened.
We check the fireplace parts in the room and route the chimney side to the services that cover it. Our findings are explained on site, and each repair is listed separately. You approve what goes ahead, with nothing started on an assumption about who pays.
A cracked or sagging face over the opening
Masonry above a fireplace opening rests on a noncombustible lintel, often a steel angle. Heat, rust or overloading can make it sag or push the masonry above it out of line. Cracks stepping up from the corners of the opening are a common sign.
We look at the lintel's ends and at the masonry it carries. A small crack may be monitored or repaired in place. A lintel that has rusted or bent is a larger structural item, and the estimate says so plainly, including what must be supported while it is dealt with.
Ask what the visit did not cover
Every inspection has limits. Parts behind finished walls, the chimney above the damper and concealed framing are not visible from the room. We tell you which of those we did not examine, and whether any of them matters for the fault you called about.
Asking about the limits is a good habit, not a challenge. It shows whether another service is needed before the fireplace can be called sound. It also helps you compare estimates, because two proposals may cover very different amounts of the system.
How the parts of a masonry fireplace fit together
A masonry fireplace is built from the base up: foundation, hearth support, firebox, throat, damper and smoke chamber, then the chimney. Brick industry guidance describes these as the basic parts. A fault in one can show up as a symptom in another.
Masonry fireplace repair therefore starts where the symptom sits and works outwards. We name the part and the material for each repair. If the fault lies in the base or in the chimney, we say which service handles that part and why.
Your fireplace repair scope in Colee Hammock
- Spark screen and its closure
- Outside air control, where fitted
- Smoke shelf debris seen from below
- Written record of the work
Masonry fireplace repair questions
Will you tell me if the fireplace should not be used?
Yes, and plainly. Some faults, such as a chipped face tile, do not affect use. Others, such as a damper that will not open or a loose firebox wall, mean no fires until repaired. We explain which applies to yours.
What does the workmanship warranty cover on a fireplace repair?
It covers the repair we carried out. It does not extend to parts we did not work on, or to damage from later use against the manual. A factory-built unit may also carry the maker's own warranty with separate terms.
Can you look at the damper behind my gas logs?
Yes. The damper and firebox around gas logs are fireplace parts. The log manual decides the damper setting, and we check that it can be held there. Faults in the logs or their controls go to our gas services.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo