Planning and installing a gas fireplace in Boca West
A new gas fireplace in Boca West starts with a free project inspection and a written scope.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a gas fireplace installation makes sense
- Planning a fireplace for a room without one
- Propane supply but no appliance yet
- A unit bought before the route was checked
- A particular look chosen for the wall
Jump to
The parts of a gas fireplace project
Hot glass and household safety at the design stage
The glass and front of a gas fireplace get hot. Where young children or others at risk live in the home, manuals advise some form of physical barrier, and many models ship with a barrier screen. Placing the unit away from walkways and furniture also helps.
If children or pets will use the room, tell us during planning. We look at the position, the height and the space in front of the unit with that in mind. Safety gates are outside our work, but we explain what the manual recommends before the design is fixed.
Ceiling height and the space above the unit
Manuals set minimum distances from the appliance to the ceiling and to anything combustible above it. Low ceilings, soffits and beams near the fireplace position can limit which models fit or where the unit can sit on the wall.
We measure the space above the planned position during the project inspection. If a raised installation is part of the design, we check that the ceiling clearances still work at that height. Those checks happen before framing, when changing the height is still simple.
Roof penetrations and the roof covering
A vertical vent route ends with a penetration through the roof. The flashing must suit the roof covering, and the vent instructions call for a storm collar sealed to the pipe above it. Roof coverings differ, and some need a roofer's work around the flashing.
We plan the roof exit with the covering in mind and agree who does what. We fit the vent, flashing and storm collar as the instructions show. If the roof covering around the flashing needs work beyond that, a roofer carries it out and it appears as their item on the estimate.
Routing a vent through the attic
When a vent passes through an attic, it needs firestops at the ceiling, an attic insulation shield, support and the clearances the vent system specifies. Ducts, trusses and wiring in the attic can affect where the pipe can go.
We check the attic during the project inspection and plan the route around what is already there. Trusses are not cut to make room for the vent. The attic section of the route, including the shield position, is described on your installation record.
What we plan and install on a gas project
- Model selection against the room and route
- Noncombustible zones kept free of combustibles
- Electrical requirement noted for an electrician
- Glass, barrier and trim fitted
Common questions on gas fireplace installs
Does a direct-vent unit need a chimney?
No. A direct-vent gas fireplace uses a sealed vent system that draws outside air and exhausts through a listed termination on a wall or roof. The route and termination must fit the manual's rules for that model.
How do you handle framing and finishes around the unit?
We follow the framing and clearance drawings in the manual for the chosen model. Where a builder or another trade frames the chase or applies the finish, we share those requirements with them before they start.
Do you handle the drywall, tile or stone finish?
No. The finish is done by your builder or a finish trade. We give them the manual's requirements for materials and clearances and check the result where it affects the appliance before we light it.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo