A gas fireplace for Coconut Grove, planned and installed
Framing, firestops and vent clearances are built as the listing requires, then covered by your finish.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Reasons to plan a gas fireplace in Coconut Grove
- An old gas unit you want replaced
- Cabinetry planned around the fireplace
- No manual for the existing unit
- Controls you would like to update
Jump to
Gas fireplace installation, from room to handover
Decorative listing or heater listing for the unit
Vented gas fireplaces come in two broad listings. Decorative units are listed to ANSI Z21.50 and are designed mainly for the look of the fire. Fireplace heaters are listed to ANSI Z21.88 and are designed to add heat to the room as well.
If warmth matters to you, say so during planning. We point you toward heater-rated models and explain what the manual says about their output and controls. If the look matters most, a decorative unit may suit. Either way, the listing on the rating plate settles which kind you are buying.
Keeping the hot front out of traffic
A gas fireplace front and its glass heat up whenever the fire runs. One manual asks for the appliance to be located out of traffic and away from furniture and draperies. Another notes that termination caps outside are also hot and should be kept clear of walkways and gathering spots.
We raise these points during planning, when moving the unit along a wall is still easy. A position that works for the view but sits in a walkway may need rethinking. Seating, curtains and doors that swing near the front are part of the conversation.
Working through the manual's installation checklist
Many gas fireplace manuals include an installation checklist covering items such as clearances, chase construction, firestops, attic shields, vent configuration, restrictor setting, electrical supply, gas pressure and finishing. Each line refers back to a page in the manual.
We complete that checklist as the job progresses, not just at the end, because some items disappear behind finishes. The completed checklist becomes part of your written record. It shows the next person servicing the unit how it was installed and what was checked at each stage.
Sealing upstairs air leaks for a natural-draft unit
Air leaking out of the upper parts of a house can pull air in lower down and work against a natural-draft fireplace. One manual lists recessed lights, attic hatches and leaking ducts among those leaks, and it suggests sealed light cans, sealed hatches and taped duct joints.
We point out those conditions when a natural-draft model is on the table. Sealing work belongs to the builder or the air handling trade, and we do not price it as fireplace work. If the conditions make natural draft doubtful, we explain why a direct-vent unit may suit the house better.
Gas fireplace work and separate trade items
- Vent system chosen from the manual
- Vent route checked against the vent tables
- Supply handover point agreed with the gas contractor
- Pressure readings and operating check
Before you plan a gas fireplace
How do you handle framing and finishes around the unit?
We follow the framing and clearance drawings in the manual for the chosen model. Where a builder or another trade frames the chase or applies the finish, we share those requirements with them before they start.
What if the wall I want has no room for the vent route?
We look for another route or another position that fits the vent tables and termination rules. If no permitted route exists for that wall, we say so plainly and suggest positions that do work.
Is the installation covered by a warranty?
Our workmanship warranty covers the installation work we carry out. The appliance and vent parts carry their manufacturers' own warranties. We explain both on the estimate so you know which covers what.
More Ways to Care for Your Fireplace
- Chimney Animal RemovalAssess occupied chimney openings and plan appropriate follow-up cleaning or entry protection.
- Chimney Masonry RepairRepair affected chimney brickwork and joints with materials selected for the construction already in place.
- Hurricane and Storm Damage Chimney RepairAssess storm-related chimney concerns and distinguish temporary protection from permanent component repair.
- Smoke Chamber RepairRepair identified smoke-chamber surfaces with the access and material requirements clearly defined.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo