New vented gas fireplaces installed in Coral Terrace
The termination position is checked against the manual before any wall opening is cut.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Situations that lead to a new gas unit
- Wanting a fire without burning wood
- An existing vent of unknown make
- A unit bought before the route was checked
- Cabinetry planned around the fireplace
Jump to
Installing vented gas fireplaces in Coral Terrace
Natural-draft units and Type B vent
Some vented gas fireplaces use natural draft. They take combustion air from the room and send combustion products up a Type B gas vent, which relies on warm gases rising. Type B vent is listed for appliances designed for it, not for every gas appliance.
A natural-draft unit needs a vertical route and enough air in the room for combustion. Exhaust fans and tight construction can work against it. We explain those conditions during planning, so you can compare a natural-draft model with a direct-vent one on facts rather than appearance.
Building a chase for the unit and vent
When a fireplace sits outside the main wall line, it usually goes in a chase, a framed box that encloses the appliance and often the vent. One manual says the chase should be built like the other outside walls of the home, insulated and sealed, and should not break the building envelope.
The same manual asks for the chase to be blocked so blown insulation and other combustibles cannot reach the fireplace or vent. We give the builder the chase requirements for the chosen model, or frame to them ourselves where that is part of the agreed scope.
The floor surface under the appliance
Manuals specify what a gas fireplace may sit on. One installation manual asks for the unit to stand on a hard metal or wood surface extending its full width and depth, and not directly on carpet, vinyl or tile. Other models set their own requirements.
We check the floor at the planned position against the manual for the chosen model. If a platform or base is needed, it is built to those requirements before the unit is set. Raising a unit is possible with some models, provided it is supported by framing and the ceiling clearances are kept.
Dust, debris and cleanup during the work
Installation involves cutting framing, opening walls or ceilings and handling packaging. We protect floors and furniture near the work area and control dust where cutting takes place.
Offcuts, packaging and old materials are removed as the job progresses. At the end, we clean up the debris and haul it away, leaving the room ready for the finish trade or for use. If other trades are working in the same room, we agree who clears what, so nothing is left behind.
Gas fireplace installation items for Coral Terrace homes
- Shutoff valve position coordinated
- Electrical requirement noted for an electrician
- Restrictor set for the vent configuration
- Leak check at the appliance connection
Common questions on gas fireplace installs
Can a gas fireplace go in a bedroom?
The fuel gas code limits gas appliances in bedrooms and bathrooms, with exceptions that include direct-vent units installed to their listing and manual. Whether your model qualifies depends on its listing, so we check that before planning the location.
Do I need an electrician for a gas fireplace installation?
Often, because many models need household power for ignition, a blower or lighting. The manual states the requirement. If a new circuit is needed, an electrician installs it, and we coordinate the timing with the appliance work.
Can you install a propane fireplace?
Yes, where the model is supplied for propane or converted as its manual allows. Your propane supplier or a gas contractor handles the tank, regulator and piping. We confirm the fuel on the rating plate before the unit is set in place.
More Ways to Care for Your Fireplace
- Smoke Chamber RepairRepair identified smoke-chamber surfaces with the access and material requirements clearly defined.
- Gas Fireplace Repair and ServiceGet a model-specific gas fireplace service plan for the fault you are seeing or the maintenance your unit needs.
- Fireplace RestorationCoordinate fireplace repairs while preserving suitable existing features and defining the intended use.
- Chimney Cap Installation and ReplacementProtect the chimney opening with a cap chosen for its fit, attachment and compatible system.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo