Installing natural gas and propane fireplaces in Edgewood
From selection to handover, a gas fireplace installation in Edgewood with no hidden fees.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a gas fireplace installation makes sense
- Planning a fireplace for a room without one
- Rust holes in the old firebox
- A builder asking for framing details
- Moving the fireplace to a different wall
Jump to
What a gas fireplace installation involves
Where a direct-vent unit gets its air
A direct-vent gas fireplace is sealed from the room. It draws combustion air from outside and sends combustion products back out through the same vent assembly, usually one pipe inside another. The glass front stays closed during operation.
That design gives more freedom over position, because the vent can end on a wall or a roof rather than needing a chimney. The freedom has limits, though. The manual sets the allowed vent lengths, elbows and termination clearances, and we plan the route within those limits before cutting anything.
Horizontal terminations and moisture
A horizontal termination sits on an outside wall. One manual asks for the termination cap to slant slightly downward so moisture in the cap can drain out. The same manual allows horizontal runs to be level rather than rising.
We set the termination and the last section of the run to the manual's instructions. The cap is fastened to the wall as shown, sealed where the manual calls for it and checked for the clearances it needs outside. A cap mounted the wrong way can hold water against the wall and the vent.
Checking the unit and parts on arrival
Appliances and vent parts can be damaged in shipping. Manuals ask installers to tell the dealer about damaged parts and not to install them. A dent or crack can affect how the unit seals or vents.
We inspect the appliance, glass, logs, vent pipe and termination when they arrive, before they are built in. If anything is damaged, we tell the dealer and wait for a replacement rather than fitting it and hoping for the best. That check is recorded, along with the serial number of the unit.
Leak check at the appliance connection
Once the supply is connected to the appliance, every fitting at the unit is checked for leaks. Manufacturers call for a non-corrosive leak check solution, applied with the gas on, at each connection the installer made.
We check the connections at the appliance and record the result. If a leak shows at a fitting on the supply side, the gas contractor is told before the unit runs. The appliance is not lit until every fitting at the unit has passed.
Gas fireplace installation items for Edgewood homes
- Control and service access planned
- Shutoff valve position coordinated
- Flashing and storm collar on roof terminations
- Existing unit and vent assessed for replacements
Before you plan a gas fireplace
Who arranges the appliance shutoff valve for a new fireplace?
The gas contractor fits the shutoff valve as part of the supply work, or it is arranged with the utility. We agree its position with them so it stays reachable after the finish. On vented decorative units it may be a remote valve that is permanently identified.
Do you handle the drywall, tile or stone finish?
No. The finish is done by your builder or a finish trade. We give them the manual's requirements for materials and clearances and check the result where it affects the appliance before we light it.
Should the fireplace go in before or after the finish work?
The appliance, framing and vent come first, and the finish follows to the manual's requirements. Some models allow certain finish materials only in set zones. We agree the sequence with your builder so nothing has to be undone.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo