A gas fireplace for Miami Lakes, planned and installed
We explain what the installation includes, what another trade handles and what is priced separately.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Where gas fireplace installations usually begin
- Unsure where a vent could exit
- Propane supply but no appliance yet
- A builder asking for framing details
- No manual for the existing unit
Jump to
The parts of a gas fireplace project
Natural-draft units and Type B vent
Some vented gas fireplaces use natural draft. They take combustion air from the room and send combustion products up a Type B gas vent, which relies on warm gases rising. Type B vent is listed for appliances designed for it, not for every gas appliance.
A natural-draft unit needs a vertical route and enough air in the room for combustion. Exhaust fans and tight construction can work against it. We explain those conditions during planning, so you can compare a natural-draft model with a direct-vent one on facts rather than appearance.
The electrical supply the model needs
Many gas fireplaces need household power for the ignition module, a blower or lighting. The manual states the requirement, and some models call for a circuit that is not controlled by a wall switch. Others can run their controls on batteries.
We read the electrical requirement during planning and mark where the supply must arrive at the appliance. Where the position has no suitable circuit or outlet, an electrician provides one. We coordinate the timing, so the power is in place before the walls close and before the unit is commissioned.
Propane tanks and regulators belong to the supplier
A propane fireplace depends on a tank, a regulator and supply piping that belong to your propane supplier or are installed by a gas contractor. Those parts set the pressure delivered to the appliance, and the manual gives the range the unit expects.
We confirm the rating plate shows propane and share the appliance's requirements with the supplier. After the supply is connected, we check pressure at the valve and complete the operating checks. If the reading falls outside the manual's range, the supplier adjusts their side before the unit goes into use.
Condensation and sounds during the first uses
Owners of new gas fireplaces often notice two things in the first weeks. One owner's manual explains that condensation can form on the glass as the appliance starts, and that it clears as the unit warms. It also describes a metallic sound as the metal expands and contracts.
We mention both during the handover, so they are not mistaken for faults. If condensation stays after the unit has warmed, or a sound is new, sharp or rhythmic, tell us. Those changes are worth checking, and we would rather look than guess.
Appliance, vent and framing items for your gas unit
- Room and appliance position review
- Framing and chase layout to the manual
- Pressure readings and operating check
- Written record of the installation
New gas unit questions for Miami Lakes homes
Who arranges the appliance shutoff valve for a new fireplace?
The gas contractor fits the shutoff valve as part of the supply work, or it is arranged with the utility. We agree its position with them so it stays reachable after the finish. On vented decorative units it may be a remote valve that is permanently identified.
Is it possible to raise a gas fireplace above floor level?
Some models allow a raised installation, provided the unit is supported by framing and the ceiling clearances in the manual are still met at that height. We check both during the project inspection, before any framing is built around the unit.
Do I need an electrician for a gas fireplace installation?
Often, because many models need household power for ignition, a blower or lighting. The manual states the requirement. If a new circuit is needed, an electrician installs it, and we coordinate the timing with the appliance work.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo