Direct vent fireplace repair for Coral Gate homes
We explain what we could see, what stayed concealed and what the vent work would involve.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Gas venting faults we are asked about
- Visible gap at a pipe joint
- Fireplace shuts down soon after lighting
- Soot marks near the draft hood
- Fire behaves oddly when fans run
Jump to
How we assess and repair gas vents
The appliance manual sets the vent rules
For direct-vent appliances, the fuel gas code points to the manufacturer's instructions for venting and to its own table for wall termination clearances. For gas vents in general, it requires installation to the vent maker's instructions and sizing to the appliance manual.
That makes the manuals the working documents for vent repair. We bring the appliance and vent instructions for your system to the job, or find them from the labels. Where the manual and the code both set a rule, the stricter one applies.
Corrosion or separation along exposed pipe
One owner's manual lists corrosion and separation among the routine checks for the venting system. Exposed pipe outdoors and in attics can rust, lose its finish or pull apart at joints over time.
We look along every accessible section for rust, holes, loose joints and damaged finishes. Surface wear is noted for watching. A section that has corroded through or separated is replaced with the listed part from the same system. Where the damage points to a wider problem, such as water entering at the roof, we explain that too.
Vent parts disturbed during renovation
Renovations can disturb a vent without anyone noticing. A joint can be knocked apart behind a new ceiling, supports removed, insulation blown against the pipe or a termination hidden behind new siding.
If the fireplace started behaving differently after renovation work, tell us what was done and where. We check the accessible route with those areas in mind and explain which sections are concealed. Access to check a concealed section is proposed as its own item, so you can decide whether it is needed.
Vent faults and appliance faults priced apart
A single visit can uncover both a vent problem and an appliance problem. We keep them on separate lines, because they are different pieces of work, often with different parts and sometimes with different urgency.
You can see what the vent repair covers and what the appliance repair would add. Some vent faults mean the appliance should stay off until they are fixed, and we say which. Appliance repairs are quoted under our gas fireplace repair service, and glass work under its own service.
Items in a gas fireplace vent repair
- Route traced from collar to termination
- Accessible joints checked for full engagement
- Listed replacement pipe and fittings
- Decorative shroud listing confirmed
Gas fireplace vent repair questions answered
Do you check the vent connector on natural-draft units?
Yes. The connector joins a natural-draft appliance to its vent, and the fuel gas code requires noncombustible, corrosion-resistant material able to handle the vent gas temperature. We check its material, joints, slope, support and clearance, and quote a replacement where it fails.
What is a draft check on a natural-draft fireplace?
After warm-up, a test at the draft hood relief opening shows which way the exhaust is moving, up the vent or back out into the room. We carry it out during vent work on draft-hood appliances.
What should I do if a carbon monoxide alarm goes off?
Get everyone outside into fresh air, then call 911 from there. Stay out until the responders allow you back in, and leave the fireplace off until the vent and appliance have been inspected.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo