Gas fireplace vent repair and replacement in Morningside
Draft problems on natural-draft units are checked at the draft hood and traced to their cause.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Gas venting faults we are asked about
- Nest or leaves at the outside cap
- Soot marks near the draft hood
- Fire behaves oddly when fans run
- Cap loose or missing after strong wind
Jump to
Direct-vent and B-vent work, step by step
A joint that has pulled apart
Vent sections join with locking features designed for each system. If a joint was not fully engaged at installation, or has been disturbed during other work, sections can separate, leaving a gap in the inner or outer pipe.
A separated joint is a reason to leave the fireplace off. We trace the route to find the joint, which may be exposed or concealed. Once it can be reached, the sections are reassembled and locked as the instructions show, or replaced where they are damaged. Access and restoration are listed separately from the joint repair.
Direct vent pipe installation for a new route
Direct vent pipe installation is needed when a route changes, a termination must move or an existing run was built outside its rules. The new route is drawn against the appliance's vent tables before any part is ordered.
We use pipe, elbows, firestops and the termination from the system the manual lists. Joints are locked as the instructions describe, supports are placed where they call for them and wall or roof penetrations are sealed. The restrictor is set to the new configuration where the model uses one.
Moving a termination to meet clearances
If a termination no longer meets its clearances, relocating it may be the answer. The new position must satisfy the manual and the code's clearance table, and the route to it must stay within the vent tables.
We look for the nearest compliant position and explain what the move involves, including new pipe, a new wall or roof penetration and closing the old one. Where no compliant position is available, we explain that too. The wall or roof finish around the old and new openings is listed for the right trade.
No manual damper in a gas vent connector
The fuel gas code does not allow a manually operated damper in the vent connector of any gas appliance. A damper that someone closes, or forgets to open, could stop the vent working entirely.
If we find a manual damper fitted in a gas vent connector, we explain the code's position and remove it as part of the vent repair. Listed automatic vent dampers and controls are a different matter, and they must be installed to their own instructions. The change is noted on your record.
What the gas venting quote includes
- Firestops and wall shields at crossings
- Attic insulation shield position
- Listed termination cap replacement
- Gas vent inside a masonry chimney reviewed
Gas fireplace vent repair questions answered
What usually blocks a gas fireplace termination?
Nests, leaves, plants and debris are the items owner's manuals ask you to look for. Later building work, such as a deck, fence, shed or enclosed porch, can also crowd a termination that once met its clearances.
Can a new window or door near the termination cause a problem?
It can. Terminations need clearances from openable windows and doors, and a new opening can fall inside them. We measure the relationship against the manual and explain whether the termination or the opening needs to change.
Do you move a termination if clearances are no longer met?
We can relocate it within the vent tables for the appliance, using listed parts. If no permitted position exists nearby, we explain the options, including changes to the nearby feature by the appropriate trade.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo