Hearth and hearth tile repairs in Boca West
Where the hearth is too small for the fireplace, we explain what the code expects and how it can be extended.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Tile, stone and brick hearth warning signs
- A crack back after an earlier repair
- Loose stones on a raised hearth
- Grout crumbling near the opening
- A raised hearth that flexes when sat on
Jump to
Factory-built and masonry hearths in Boca West
A larger opening needs a larger hearth
Under the code, a masonry hearth extension grows with the fireplace opening. Once the opening passes a certain area, the extension has to reach further in front and further to each side.
When an opening was enlarged in an earlier project, the hearth may not have grown with it. We measure the opening and the extension on the visit and tell you whether the two still match. If they do not, extending the hearth goes onto the estimate as a separate, clearly described item.
A factory-built hearth has to stand out
For factory-built fireplaces, the code adds that the hearth extension must be readily distinguishable from the surrounding floor. The idea is simple: people should see where the protected area begins and ends.
A hearth finished to blend into matching floor tile, with no visible edge, may not meet that rule. When we repair or replace such a hearth, we discuss how the edge will be made clear. A change of material, a border or a raised lip can each do it. You choose the look within that requirement.
Tile and marble are finishes, not insulation
It is easy to assume that a thick stone or tile surface protects the floor on its own. Maker's tables tell a different story. Tile and marble conduct heat readily, and they would have to be very thick to match the insulating board a listing may call for.
That matters when a factory-built hearth is rebuilt with a new finish. Swapping the finish is fine; dropping the insulating board beneath it is not. We keep the layers the manual requires and explain which layer does which job, so the new hearth looks right and still protects the floor.
Loose edges and lifted tiles underfoot
A lifted tile or a loose edge on a hearth is a trip hazard as well as a fireplace fault. Hearths sit in busy parts of the room, and people step on and around them daily.
Where a loose piece could catch a foot, we can make it safe on the day, with your approval, until the full repair. The permanent repair then follows on the agreed date. We note both steps on the estimate so you can see what is temporary and what is final.
Hearth repair lines you can approve separately
- Hearth size checked against the opening
- Combustible material under the hearth checked
- Metal hearth strips where the manual requires
- Temporary make-safe for loose edges
Hearth support, size and finish explained
Is my hearth big enough for the fireplace?
That depends on the fireplace. A masonry fireplace follows the code's rules for the extension, which grow with the size of the opening. A factory-built unit follows its own manual. We measure both on the visit and tell you plainly whether the hearth falls short.
Can a rug sit on top of the hearth?
The hearth extension is meant to stay clear and noncombustible across its whole area. A rug over it sits exactly where embers land. Keep rugs off the hearth and back from its edge, and move them before our visit so we can see the whole surface.
What should I move off the hearth before the visit?
Plants, baskets, log holders, decorations and any rug in front of it. Let the fireplace go cold, and leave loose pieces where they are. Set out any spare tiles, an old invoice or the manual for a factory-built unit.
More Ways to Care for Your Fireplace
- Chimney Liner Installation and ReliningPlan a compatible chimney liner installation with the existing passage, connections and maintenance access considered together.
- Chimney TuckpointingRenew deteriorated mortar joints around chimney bricks that can appropriately remain.
- Firebox RepairRepair the damaged fireplace chamber using an approach suited to masonry or manufactured components.
- Top-Sealing Damper InstallationFit a top-mounted damper only after checking the fireplace, product restrictions and control route.
- Chimney Leak RepairFind the chimney water entry point and plan a repair before restoring the damaged finish.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo