Fireplace hearth repair and replacement in Westwood Lakes
Hearth repair in Westwood Lakes that respects both the fireplace behind it and the floor around it.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Hearth cracks and loose pieces to mention
- Cracks running across several tiles
- Chipped or loose edge pieces
- Slate flaking near the fireplace opening
- A dark joint that stays damp
Jump to
How we repair a cracked or loose hearth
How a hearth is held up
A hearth extension needs support that will not burn and will not move. Brick industry guidance describes corbelled brickwork, a structural concrete slab and a reinforced brick cantilever as common ways of carrying it. On a ground-floor slab, the slab itself may provide the support.
The type of support shapes the repair. A cracked tile over a sound slab is a surface job. A crack along the line where a cantilever leaves the wall may point to movement in the support. We identify the support where we can, and say plainly when we cannot see it from above.
What we check on a hearth visit
We look at the whole hearth extension: its size relative to the opening, the surface, the joints or grout, the edges and the junction with the firebox floor. Tapping shows hollow areas, and a straight edge shows dips.
For factory-built fireplaces we add the manual's requirements, such as strips, seals and the base beneath the finish. We explain what we found before we leave, including what could not be seen, and the written estimate follows. Where something looks wrong but the cause is unclear, we say so rather than guess.
Building out a hearth that is too short
Where a hearth extension is too small for its fireplace, extending it adds noncombustible floor where the rules call for it. The new section needs the same kind of base and support as the rest.
We plan how the extension will join the existing hearth and how its finish will match or contrast. We also plan how the room floor will be cut back and finished at the new edge. The estimate shows the extension, the floor edge work and any finish choices as separate lines.
Setting tile close to the heat
The adhesive under a hearth tile sits near the fire and takes heat with every use. One factory-built fireplace maker recommends unmodified thinset for tile near its units because of the temperatures involved. Product directions set the rest.
We name the setting material on the estimate and follow its directions for mixing, coverage and curing. Tiles that failed because they were stuck down with an unsuitable adhesive are lifted, the old bed is cleaned off and the base is checked. Laying new tile on the same failed bed would repeat the fault.
The hearth scope you approve
- Surface tapped for hollow areas
- Grout and mortar joints checked
- Support type identified where visible
- Optional sealing on its own line
Hearth repair in Westwood Lakes, your questions
Can the fireplace be used before the hearth is repaired?
Sometimes. A cracked tile on a sound base rarely stops fires. Missing pieces, loose edges near the opening or gaps into a void below should stop them. We give you a direct answer on the visit and explain the reason.
How does the inspection discount work for hearth repairs?
Save 10% on the hearth lines you approve, provided you book them within 72 hours of your free inspection. The hours run from your own inspection visit rather than from your call. If you decide later, the estimate keeps its written price.
Is it safe to sit on a raised hearth?
A sound raised hearth is built to carry its own weight and the loads placed on it, including people sitting on the edge. Loose capstones or corners are a different matter. Keep off loose sections until they are reset, and mention them when you book.
More Ways to Care for Your Fireplace
- Chimney Leak RepairFind the chimney water entry point and plan a repair before restoring the damaged finish.
- Firebox RepairRepair the damaged fireplace chamber using an approach suited to masonry or manufactured components.
- Gas Fireplace VentingAssess and repair the gas fireplace vent arrangement using components suited to the identified system.
- Chimney Animal RemovalAssess occupied chimney openings and plan appropriate follow-up cleaning or entry protection.
- Chimney Liner Installation and ReliningPlan a compatible chimney liner installation with the existing passage, connections and maintenance access considered together.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo