Stone veneer chimney repair in Palmetto Bay, backing first
Upfront prices, a workmanship warranty and a written record come with every stone repair we carry out.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Stonework changes worth a closer look
- A section of stone bulging outward
- Rust streaks running down the stonework
- Stone buried in the roofing at the base
- Gaps where the stone meets the chimney top
Jump to
Our stone chimney repairs in Palmetto Bay
Getting new joints to blend with old ones
New mortar is darker when wet and lightens as it cures. Judging a color match on the day it goes in can mislead. The sand in the mix drives most of the final color and texture.
Where joints will be visible, we prepare a small sample and judge it once it has dried. National Park Service guidance on repointing stresses matching color and texture as well as strength. You see the dried sample before the full repointing goes ahead, and you can ask for an adjustment.
Joints where stone meets other materials
Where stone meets siding, trim or another finish, the joint needs to allow movement and stay sealed. The manufactured stone guide calls for flashing and sealant at penetrations and at transitions between materials. Old sealant is cut out completely before new material goes in, since fresh sealant does not hold well on old.
We check those joints for cracks, gaps and missing sealant. Resealing them takes little time and shuts off an easy route for rain. It is listed as its own item, with the materials named, so you can see what went into each joint.
Checking the repair once it has cured
Fresh joints can show hairline shrinkage at their edges, and a reset stone should sound solid when tapped. We check both before the job is signed off. Joints are also checked for depth and profile against the surrounding face.
Any small defects are dealt with while the area is still accessible and the materials are on hand. The condition of each repaired area at handover goes into the written record, so there is a clear reference if a stone or joint is questioned later.
Different metals meeting behind the stone
Put two unlike metals together in a wet, salty setting and one of them can be eaten away while the other survives. The American Galvanizers Association describes this galvanic effect for zinc-coated steel beside copper or stainless parts, and a coastal location makes it more likely. Fasteners are the usual weak point, because they are small and touch everything.
When flashing, ties or fasteners on a stone chimney near the coast need replacing, we look at what each new part will touch. Unlike metals are separated or avoided, and the materials chosen are written into the estimate.
What the stone inspection and estimate include
- Agreed removal of loose or displaced stones
- Resetting stones in a full mortar bed
- Open areas covered at the close of each work day
- Written record of stones reset and replaced
Stone chimney repair questions
How long does a stone chimney repair take?
It depends on how many stones need resetting, whether backing work is involved and the weather, because mortar needs curing time. We give you the planned sequence together with the estimate.
Why is water getting in behind the stone on my chimney?
Common routes include the top, open joints, the roof junction and a blocked drainage edge at the base. We check each one and, when the job calls for it, use a hose water test to confirm the route.
What should I mention when I call about stone damage?
Say which stones moved or fell, where they are, whether the area gets wet after rain and any past repairs. If you know the stone product or who installed it, mention that too.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo