Stone veneer chimney repair in Seven Isles, backing first
Homes in Seven Isles get the same order of work from us: water first, backing next, stone last.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Stone and joint problems to point out
- Thin gaps around individual stones
- Pieces of stone or mortar on the roof
- A section of stone bulging outward
- Loose stones above a door or walkway
Jump to
Stone chimney repair in plain terms
Anchored stone veneer and its ties
Anchored veneer stands slightly off the wall behind it and is held there by corrosion-resistant ties. The Florida Building Code's section on anchored stone and masonry veneer also calls for flashing and weep openings, so water in the space behind the stone can escape.
If ties corrode or weeps clog, stones can loosen and water can collect behind the face. We look for rust stains, bowing and blocked weeps during the inspection. Tie repair or replacement is described in the estimate when the evidence points that way.
The weep screed along the bottom of stone veneer
On a framed wall, adhered stone usually ends at the bottom on a weep screed. The industry guide holds that edge clear of the roofing, ground or paving below, so water can leave and the stone stays out of standing water.
A weep screed buried under roofing, mortar or soil stops working. We check its condition and its clearance. If it needs to be freed or reset, the stones above it may have to come off and go back, and the estimate says so in plain terms.
Replacement pieces for manufactured stone
Manufactured stone comes in many profiles and colors, and product lines change over time. An exact match for a chimney finished long ago may no longer be made. That is worth knowing before any stone is removed.
We start by looking for the original product if you have any record of it. Otherwise, we compare current options in daylight against your stone. The industry guide advises mixing sizes, shapes and colors when laying stone, and we use the same idea to help new pieces blend among the old.
Loose stone above doors and paths
A loose stone above a door, path or patio is a safety concern. Stones can fall without warning, and even small pieces are heavy enough to hurt someone. Pieces can also break when they land and scatter over a wide area.
Leave the stone where it is and keep the space beneath it clear. Mention it first when you call, because we check hazards like that before anything else on the visit. Should it need taking down, we explain why, lift it off carefully and list it in the record.
What your stone repair estimate covers
- Loose stone mapping across each face
- Scratch coat or lath repair behind adhered veneer
- Gentle cleaning of mortar smears
- Open areas covered at the close of each work day
Stone repair answers for homes in Seven Isles
How long does a stone chimney repair take?
It depends on how many stones need resetting, whether backing work is involved and the weather, because mortar needs curing time. We give you the planned sequence together with the estimate.
What mortar do you use for repointing stone?
One chosen for the stone and the assembly. For natural stone, the mortar should not be harder than the stone. Manufactured stone follows its maker's guidance. We explain the choice rather than using one mix everywhere.
Can I keep using the fireplace during exterior stone work?
Exterior stone work seldom affects the fireplace. Where a repair reaches the chimney top or the inside of a framed chase, we say whether fires should wait until that section is closed up again.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo