Storm-related chimney repair for Margate homes
Water that showed up after the storm is traced to its entry point before any repair is chosen.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Storm damage signs on chimneys in Margate
- Cap bent or hanging to one side
- Chimney top leaning or out of line
- Banging from the chimney top in gusts
- Tree limb resting against the chimney
Jump to
Storm damage chimney repair, planned for Margate
Chase covers shaped to shed water
A flat chase cover can hold water and rust through. Makers of chase covers offer diagonal creases, called cross-breaks, that raise the center, and a drip edge that throws water clear of the siding. A skirt runs down the sides of the chase.
When a storm damages a flat cover, replacing it with one shaped to shed water is often the better repair. We measure the chase, the pipe opening and the skirt, and explain the shape we propose. The new cover is fastened so wind cannot work it loose as easily.
The storm collar on a metal flue
On a factory-built chimney, a storm collar sits on the pipe just above the chase cover. It sheds water away from the gap where the pipe passes through. Instructions for a listed chimney system can call for it to be sealed to the pipe with a waterproof sealant.
Wind can loosen the collar or crack its seal, and water then runs down the pipe into the chase. We check the collar, its bolt and its seal. A sound collar is reset and resealed. A bent one is replaced with the part the chimney maker lists.
When the water appears tells us where it enters
The timing of a leak is a clue. Water that appears only during wind from one direction may be entering through the side of the chimney or the flashing. Water that appears a day or more later may have soaked through masonry first.
Tell us when you first saw the water and what the weather was doing. That timing narrows the search before anyone goes up. It saves guesswork and helps us repair the entry point rather than the stain.
White deposits after a soaking storm
A chimney soaked in a storm may show white, powdery deposits on its faces as it dries. Brick industry guidance explains that water moving through masonry carries dissolved material to the surface, where it is left behind.
The deposits are a sign of where water moved. We note them and look for the entry point that let the water in. Once the source is repaired and the masonry dries, the deposits can be cleaned with a suitable method. Cleaning before the source is fixed only brings them back with the next soaking rain.
What the storm damage estimate lists
- Temporary cover over an open flue
- Hose water test when the job calls for it
- Listed parts for factory-built chimneys
- Written record of the storm repairs
Common storm damage chimney questions
The chase cover lifted in the wind. Can it be refastened?
Sometimes. If the metal is still flat and sound, it may be refastened and resealed. If it is bent, torn or rusted, a new cover shaped to shed water is the better repair. We explain which applies.
Is a factory-built chimney repaired differently after a storm?
Yes. A factory-built chimney is a listed system, so damaged pipe, storm collars, caps and chase-top parts are replaced with parts the manufacturer lists. The label on the fireplace or chimney helps us identify them.
Do you clean up the chimney debris after storm repairs?
Yes. Debris from the damaged chimney and from our work is cleaned up and hauled away. If the work runs over more than one day, an open chimney is covered at the close of each work day.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo