
Hollow or bulging chimney stucco repaired in Pembroke Pines
If the repair area grows once the wall is open, you approve the change before we continue.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Stucco cracks and bulges worth mentioning
- Rust spots lined up in rows
- White powder on the stucco surface
- A long crack near the roof line
- Stains in the attic near the chimney
Jump to
Stucco repair choices for Pembroke Pines chimneys
Why stucco goes on in separate coats
Stucco is built up in layers rather than one thick pass. A first coat grips the base, a second coat brings the surface level, and a thin finish coat carries the texture and color. Each layer has its own mix and its own job.
The Florida Building Code's exterior plaster section asks for more coats over lath than over masonry, and it points to the standard for plaster application. A repair should rebuild the removed coats in order. A single thick patch skips that sequence and can shrink and crack as it dries.
A family-owned team on your stucco chimney
We are a family-owned, locally owned company. The person who explains your stucco repair is part of the team that stands behind it, and that shapes how we talk about the work.
We explain the base, the cause and the options in plain terms, and we tell you when a smaller repair is enough. If something is outside our scope, we say that too, rather than stretch a job to fit. You get a straight account of the chimney and the choice of what to do next.
Why stucco is not cleaned with high pressure
High-pressure washing can drive water into cracks, erode the finish and loosen weak plaster. On a chimney, it can also push water past the top or the flashing and into the house.
The National Park Service suggests low-pressure washing and soft brushes for stucco, and warns that textured surfaces are hard to clean without removing some of the texture. If the chimney has been pressure washed recently, tell us, because that can explain fresh cracks or damp areas we find during the visit.
Where chimney stucco meets the house wall
The corner where a stucco chimney meets the wall of the house often cracks in a long vertical line. The chimney and the wall can move a little differently, and the plaster across the joint takes the strain.
A rigid patch across that line may simply crack again. Depending on what we find, the better answer can be a flexible joint or a flashing detail rather than more plaster. We explain the choice and show where the joint will sit before any work starts.
What we check before pricing stucco work
- Corner and casing beads checked
- Color sample for exposed faces
- Adhesion check on the existing coating
- Protection for paving and plants
Before you approve stucco work in Pembroke Pines
How many visits does a stucco repair usually take?
Usually more than one, because each coat needs to cure before the next goes on. The exact plan depends on the size of the repair and the weather. We set out the likely sequence in the estimate, and the curing gaps do not change the agreed price.
Do you fix the source of the water as part of the job?
We find the source during the inspection. If it is the chimney top, the flashing or another component, that repair is listed as its own item with its own price. You decide on each item, and we explain why the order of the work matters.
When is a hose water test part of a stucco job?
No. We run a hose water test only when the job calls for it, usually when the entry point is still unclear after the inspection. We explain why it would help before doing it.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo
