Stucco chimney repair in Tamiami, coat by coat
Stucco repairs in Tamiami come with a written record of the areas, materials and coats.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
How failing chimney stucco shows itself
- Cracks running through the stucco finish
- Paint peeling on one chimney face
- A long crack near the roof line
- Stucco pulling away at a corner
Jump to
Stucco repair details that decide the result
Corrosion-resistant lath and fasteners by code
The Florida Building Code's exterior plaster section requires lath and its attachments to be corrosion-resistant. It also points to the ASTM standards for how lath is fastened and how plaster is applied.
When we replace lath in a repair area, the new lath and fasteners follow that requirement. We fasten the new lath into sound framing or backing and lap it with the lath that stays. The estimate names the lath and fastener type, so you can see what is going behind the finish.
Refastening or replacing loose lath
Sometimes the plaster is sound but the lath behind it has pulled away from the framing. Stucco on loose lath can flex, crack and eventually drop away.
Where the lath is still in good condition, it can often be refastened before the patch goes on. Where it has corroded or torn, the damaged section is cut out, and new lath is fastened and lapped into what remains. Either way, the backing is secured before new plaster is applied, and the estimate says which approach we expect to use.
An approved opening to see behind stucco
Sometimes nothing short of a small opening will show what sits behind the stucco. We suggest one when the evidence is mixed and the answer would change the repair. It is a controlled step, planned in advance, not a demolition.
The opening is agreed with you in advance, including its location and how it will be closed. It is listed as its own item. We protect the opening while it is open and describe what we found, so you can decide on the repair with the facts in front of you.
Mixing only the stucco that can be used
Stucco starts to stiffen soon after it is mixed. The National Park Service advises mixing only as much as can be used within a working period and discarding the rest rather than adding water to loosen it.
Retempered plaster is weaker and can craze or crack. We mix small batches for chimney patches, sized to the area in hand. The same care applies to overmixing, which that guidance links to crazing, discoloration and poor bonding. It is a small discipline that shows in the finished repair.
Stucco work we separate on the estimate
- Weep screed at the base checked
- Sealant at stucco transitions
- Full-face refinish priced as an option
- Hose water test when the job needs it
Chimney stucco questions we hear in Tamiami
Is an elastomeric coating a good idea for a stucco chimney?
It can be, on sound stucco where the water source has been fixed. Because it forms a film, it can slow drying if water gets behind it. We read the product data and look at how the chimney dries before recommending one.
What should I mention when I call about stucco damage?
Tell us which face is damaged, how large the area looks, whether pieces have fallen and whether there are damp marks inside. Mention any earlier patches. You can reach us by phone to arrange the free inspection.
Will you need to go into the attic?
Only if there is safe access and the chimney passes through it. The attic can show stains or damp sheathing that explain the outside damage. If you prefer we stay outside, tell us, and we note that the attic was not checked.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo