Stucco repairs that blend into chimneys in Washington Park
If the repair area grows once the wall is open, you approve the change before we continue.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Stucco trouble you can spot from the yard
- Cracks running through the stucco finish
- White powder on the stucco surface
- Dark streaks below the chimney top
- A long crack near the roof line
Jump to
Planning a stucco chimney repair in Washington Park
The leveling coat under a stucco finish
The middle coat, often called the brown coat, builds the patch out to the plane of the surrounding wall. It carries more sand than the finish and does most of the work of making the repair flat.
If this coat stops short or sits proud, the finish cannot hide it, and the patch shows as a dip or a bump in low sunlight. We check the level against the old stucco around the repair before the finish goes on. That check is quick, and it saves a repair that only looks right from straight ahead.
Stop the water before the stucco repair
The National Park Service identifies water as the main cause of stucco deterioration. Water that keeps reaching the plaster from above or behind will undo a patch, however carefully it is made.
We therefore look for the entry point before we price the plaster work. It may be the chimney top, the flashing at the roof, a gutter, or rain splashing up from the ground. If the source belongs to another repair, it appears as a separate item, and we explain the order in which the work should happen.
Tying a new stucco system into existing details
A full restucco is a chance to correct details that caused problems before. New lath, barrier layers and flashing have to be joined properly to the parts of the house that stay. Getting those joins right matters as much as the plaster itself.
The International Masonry Institute stresses integrating new lath, barriers and flashings with the existing systems. On a chimney, that means the roof junction, the top, the base and any place the stucco meets another material. We describe each of those transitions in the estimate, so none is left to chance.
Foam-backed finishes that only look like stucco
Some chimneys are clad in a foam-backed finish system that looks like stucco from the ground. It is a different assembly, with foam board, a reinforced base coat and a thin finish layer. Tapping it sounds and feels different from cement plaster.
Those systems have their own repair methods set by their makers, and a cement stucco patch is not the right fix. We identify which material you have during the inspection. If it is a foam-backed system, we tell you plainly and explain what that means for the repair.
Included in a stucco chimney assessment
- Scratch coat keyed to the base
- Moist curing between coats
- Paint on repaired areas where included
- Open top covered at each day's end
Stucco chimney questions asked in Washington Park
What happens if there is rotten wood behind the stucco?
We stop at the agreed boundary and show you what we found. The wood repair is chimney chase repair, a separate item with its own price. The stucco work resumes once the support behind it is sound and you have approved both parts.
What does the free inspection include for a stucco chimney?
We look at every accessible face, tap for hollow areas, and check the top, the roof junction and the base. We explain what we saw and what we could not see. A free written estimate follows, with each item priced separately.
Do you clean up the dust and debris afterward?
Yes. We protect the ground and surrounding surfaces during the work and tidy the area each day. Old stucco, lath and other debris are cleaned up and hauled away when the job is finished.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo