A chimney top damper fitted properly in Croissant Park
Round flue, stainless liner or square tile, the damper and its adapter are matched to it.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Reasons to ask about a top damper in Croissant Park
- Throat damper rusted shut or missing
- Daylight visible up a closed flue
- Handle bracket loose in the firebrick
- Plans to leave the fireplace idle
Jump to
Top damper decisions for homes in Croissant Park
How we show you the damper works
The last part of the job happens at the fireplace. We show you the handle, the open and closed positions and how the lid responds. You try it yourself, so the first time is not alone with a fire waiting.
We also point out the set time before the next fire and anything we noticed that was outside the job. One maker's instructions ask the installer to review the operation with the customer, and we treat that as part of the work, not an extra.
When there is no throat damper left
In some fireplaces, the throat damper has rusted through, fallen out or been removed during earlier work. The frame may still be there with no plate, or nothing may be left at all. The flue then stands open all the time.
A top damper is one way to give that fireplace a working closure again. A new throat damper is another, where the throat can take one. We look at the throat and the flue and explain which route suits the fireplace. The estimate prices each so you can compare.
The written record of the damper work
Once the damper is in, you receive a written record of the work. It gives the make and model, any adapter or plate, how the frame was fixed, where the bracket sits and what happened to the old throat damper. The set time before the next fire is on it too.
Keep the record with the fireplace paperwork. It helps if the damper ever needs parts, and it tells the next person working on the chimney what is at the top. Items we noticed but were not asked to repair are listed as well.
The order a top damper job follows
A top damper job runs in a set order. We confirm the fuel and product limits, check the flue for animals and debris, and clean the tile top. Any tile or crown repair you approved comes next. Then the frame is set in adhesive, the cable fed down and the bracket fixed.
After that, the lug is set, the seal checked from the roof and the operation shown to you. Following that order keeps the damper from being fitted over a problem. If your job has stages or a wait, the estimate lists them in sequence.
Included in your damper visit in Croissant Park
- Flue shape and size measured
- Damper model and material named
- Gasket type and seal check
- Firebox protected during drilling
Top mount damper answers for homes in Croissant Park
Does a top damper replace my old throat damper?
It takes over the job of closing the flue. The old throat damper is then fixed open, removed or left in place, depending on its condition and the fireplace. We explain which applies and list it on the estimate.
How soon can I use the fireplace after installation?
The adhesive under the frame needs time to set before the fireplace is used. We tell you the maker's set time at handover and write it on the record, so the next fire waits until the seal is ready.
Where does the handle go inside the fireplace?
A bracket is anchored into the firebox wall on the side you find easier to reach, and the cable passes through it to the handle. We drill with a masonry bit and set the anchors carefully to avoid cracking the firebrick.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo