Vent-free fireplace service and repair in Brickell Key
The ODS pilot is cleaned, tested and replaced only with the listed part for your burner system.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs a ventless gas fireplace needs service
- Igniter clicks with no flame
- No spark at the pilot
- Flames orange, stringy or lazy
- Flame changed after cleaning
Jump to
Servicing the ODS pilot, burner and logs
What a normal vent-free flame looks like
Vent-free manuals describe and often picture a normal flame for the model. One log set manual describes a normal flame as lively, with blue and yellow in it. What matters is the shape, the height and whether the burn stays clean, with no soot once break-in is over.
We light the unit and compare the flame with the manual rather than with a general rule. If the flame matches, we tell you so. If it does not, we trace the difference to the ports, the air opening, the embers, the logs or the pressure.
Keeping added decorations off vent-free burners
Pine cones, glass beads, extra stones or a log from an old set can look appealing on a burner. Vent-free manuals allow only the listed accessories for the model. Anything else sits in the flame path the listing did not test, and it can cause soot or change the pilot's air.
If decorations were added, we remove them and explain why. Where the maker offers a listed decorative kit, we can tell you about it. The unit then burns as tested, which is the whole point of the listing.
Log placement on a vent-free set
Every vent-free log set comes with a placement diagram. The logs sit on pins or notches, and the flames are meant to pass between them, not into them. A log shifted even slightly can put flame against its surface, and soot builds there.
We reset each piece to the diagram and check that flame contact matches what the manual shows. If the diagram is missing, we find it from the model number. We also note the placement in the written record, so a later dusting does not undo the setup.
Fireplace doors and a vent-free burner
Where a vent-free log set sits in a fireplace with glass doors, the log manuals require the doors to be fully open whenever the burner runs. Closed doors starve the flame, which can lead to soot and pilot outages. The rule applies even for short burns.
We check the doors and explain the rule for your set. We do not install or change fireplace doors. If a door frame sits low across the opening, the manual may have more to say, and we read that section with you.
Where the ventless repair scope starts and stops
- Thermocouple or thermopile output check
- Log positions reset to the diagram
- Gas control knob and valve operation
- Screen and liner panels inspected
Ventless gas fireplace questions from Brickell Key
How is an ODS pilot cleaned during a service visit?
With the unit off and cool, the pilot area is brushed lightly while loose debris is vacuumed away, so nothing goes into the pilot opening. The air intakes are cleared, and the flame is compared with the manual's picture afterward.
Is a vent-free unit meant to heat the whole house?
No. The Florida fuel gas code says unvented room heaters may not be the sole source of comfort heating in a home, and the manuals call them supplemental. They warm a room, with that room's air and volume in mind.
Will you work on the gas piping that feeds the fireplace?
Supply piping belongs to a gas contractor or your gas utility. We check the appliance side, take pressure readings at the valve where it allows and tell you plainly if the supply is the problem, so the right trade handles it.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo